Forum Replies Created
-
AuthorPosts
-
lokring
ParticipantRe: Cleaning Stainless Steel Fridge doors
wd40 works a treat 😀
lokring
ParticipantRe: Maytag LAT9606GGE Buzz
yup the centrifugal switch is part of the motor 😀 part no p 207424 about £200
lokring
ParticipantRe: Whirlpool AWG320
short circuit coil on fill valve it took me a while to find this one. you remember the bad ones……
lokring
ParticipantRe: Maytag LAT9606GGE Buzz
if someone says my washer is “buzzin” in my area its a good thing!!
remember the peter kay sketch about the cinama and screen 3 buzzin 🙂
lokring
ParticipantRe: Maytag LAT9606GGE Buzz
siezed or sticking drain pump is another possibility!!
so next time its buzzin take of the belt and if the motor runs ok then try turning the pump by hand…good luck!
lokring
ParticipantIt was around £50
lokring
ParticipantRe: Sios Disk
whirlpool uk ltd
02086495000 🙂 and no its not timebombed !!!they just knock off the old models to fit on the new ones. 😀lokring
ParticipantRe: belling cookcenter
have a close look around the main terminal block i seem to recall a bad spade on it causing something on those lines………..
lokring
ParticipantRe: Common Refrigerator Hints
i wouldnt change the calibrayion on anything if if goes up in flames your up the creek without a boat or a paddle!!!!!!!
February 20, 2007 at 8:41 pm in reply to: Fridge Choice:Fisher & Paykel E522BLXFD v Maytag Trilogy #204975lokring
ParticipantRe: Fridge Choice:Fisher & Paykel E522BLXFD v Maytag Tri
check your pm’s 😀
February 20, 2007 at 8:24 pm in reply to: Fridge Choice:Fisher & Paykel E522BLXFD v Maytag Trilogy #204973lokring
ParticipantRe: Fridge Choice:Fisher & Paykel E522BLXFD v Maytag Tri
i would put my money on a maytag or admiral and consider the side by side rather than the trilogy 😀
lokring
ParticipantRe: Hotpoint Mistral FF65P
sorry i mean is it goin at full crack!
lokring
ParticipantRe: Hotpoint Mistral FF65P
is the condenser fan working ok??
lokring
ParticipantRe: zanussi DA6141 wont fill
a few years back i had a zanussi with one of those “poggs”in the presure chamber i visited it as engineer no8 coz it had been with 2 preure switches 2 timers and i had a cutomer with a very red face …….on very close inspection i found this “pogg” in the chamber, removed and tested it and hey presto! all fixed it cost the firm about £300 in wasted parts and all for something we could have charged the customer for. as it was a warranty call……….. 😀
lokring
ParticipantRe: zanussi DA6141 wont fill
i would strip down the presure system and wash it out ……if you blow down it your not realy able to know if its full of “crud” or soap scum i would remove and clean it mate…..
-
AuthorPosts
