Forum Replies Created
-
Posts
-
Re: Whirlpool Washing Machine AWM324/3 On/Off Switch
Hi, order 481941029004 and that will do the job. The 2 blue wires are for the neon but you won’t be able to connect them to new switch. This switch is off of a dishwasher but has the same fitting.
Re: Zanussi FJS1225w PNC 914512801(00), err flashing and con
Hi, went back, heater ok. all parts ok apart from lights flashing all over the place. Settled on getting him new machine as it is 7 yrs old. Was wondering that it wasn’t an element as i had already tested it and only selected the machine on a rinse. Thanks anyway for your help.
Re: Zanussi FJS1225w PNC 914512801(00), err flashing and con
Cheers, I’ll go back and have another look
Re: Zanussi FJS1225w PNC 914512801(00), err flashing and con
Yes i have and ok. I only ran it on a rinse and the jet pump was running all the time and drum was turning. Do you know if the jet pump runs all the time as i haven’t ever seen this model please?
Re: Zanussi Jetsystem FJS1225w. err
it didn’t seem to me that it tried to empty but i see where you are coming from. Am i right by saying that the jet pump runs all the time during all the washes and rinses or is it just for a while?
Re: Zanussi Jetsystem FTS1225w. error and lights flashing
Sorry. Its an FJS1225w PNC 914512801(00), ser no 21200483
cheersRe: Hotpoint wm62 spinning problems
sorry i misread your earlier comment Martin. I am going in the morning so i will check all things above. cheers
Re: Ignis Oven AKL437
Have you disconnected to clear board? if you have and still the same, change the board
Re: Whirlpool American S20D 8586 158 15000
Check that the water inlet pipe in the top of the freezer hasn’t frozen up. If it has…hairdryer. If you have no optic lights on the infra-reds in freezer…new control board will sort it.
Re: Beko WMA 520s w/m blowing fuses
Thanks gents. Plugged in new motor and ok. Fault didn’t show on my megger. getting my megger tested i think. Cheers
Re: Beko WMA 520s w/m blowing fuses
Thankyou, i will try that as i am going back to try again. many thanks and thanks for the welcome
Re: Beko WMA 520s w/m blowing fuses
I feel like i have covered everything. Done all of the above. I repair quite a few bekos but have never had to look too deep. Was wondering what the pcb does as soon as lock is energized. Some do a little diagnoses. when i took the board out, i looked on both sides of the board and no signs of burning. The controls seem to work. i already ran on drain only cycle with the pump unplugged and the same thing happened. i did a test on the motor and seemed ok too. The RCD is ok as well as i tested the circuit. This has got me scratching my head. Many thanks
