Forum Replies Created
-
Posts
-
Re: Suggestion Box
Hi, I am having only 1 problem. I need more than 1 of everything. I have 2 other engineers and we only have 1 stock. Is there any chance of 2 more van stocks please?
Re: Bosch w/m Enr: WVD24520GB/04 stuck on 1 min left
Hi, bit late replying here. Tried everything on this. id the door lock and heater. I then looked at tech on bosch website and it said about the 1 min left scenario. It asked me if there was a power cut??? It turned out they had a powercut and someone moved the timer. It turned out that if someone moves the timer knob when the power has been lost, It comes up with 1 min left. Its to tell you that your not on the right program. As i went through the tech info, the tenant came in and moved the timer back to the original program. Lol Why didn’t he do that b4 he rang me? The stupidest faults i’ve ever had. Not for 1 min did i think the timer had been moved. If that happens again, i will go through every wash until it clears. Thanks anyway cos i’ve learn’t a lot. Its been emotional!!! 😯
Re: AEG 40250I-W D/W Prod no.91123454201 mod motor change
cheers for your help. I found a lux engineer who got the tch info for me. Very strange but the mains coming in goes through the motor plug. I put the new motor on and through crimps the mains and all is now well.
Re: Bosch dishwasher SGS5342GB/17 FD8011130111 stuck at 13
Haqve you checked for water in the basin?
Re: Whirlpool AWG345/4
Definately main Pcb board. I never get anything Whirlpool for landlords anymore due to cost of spares. They have priced themselves out of the market. Machine just goes dead.
Re: re whirlpool american top loader 3RLSQ8000JQ
Hi, the fuse in the top loader is in the top control panel usually taped to the wiring loom. This fuse can blow at any time from what appears to be no reason at all. If its a heavily used machine then I’m not surprised. When I used to work for Whirlpool I asked their tech man why this happens. He said its earth leakage from the motor if its a heavy used machine. He then said its a heavy domestic machine and should have 20mins rest between cycles to let motor cool down. I hope this helps
Re: ZDT6041 Zanussi dishwasher
Hi mate, I think you will need to put a new door lock anyway cos that sounds like its faulty as machine runs with door open. I would repair that 1st and see what happens…u never know???
Re: Zanussi Guarantee ZWF 1207
I’ve written off 4 Zanussi washers in the last 4 months. I’ve replaced everyone of them with ISE AW23’s. At least you can do a bearing change on them at a fraction of the cost. I can’t believe LUX are making this crap. They as far as i’m concerned are the worst machines money can buy. The worst cabinets, strange faults, sealed tubs with crap seals and bearings. What next? I reckon soon the drain pump, motor and control board will be sealed in so if anything goes it will goodbye :o(
Re: Diplomat APM6855-1 No supply to fan
I did yes and the fan moved very slightly and then nothing. I took the door sensor out and i had 240v on each side of resistor. Could this be a faulty door sensor?
Re: New Beko CDA647FW/1 Pcb with no guarantee from masterpar
it was only £10+vat from masterpart. I’m at a loss with this fridge. load of crap
