Forum Replies Created
-
Posts
-
Re: Hotpoint FDW70G SN709111927 – Sticking
I thought that but This has a sensor that clips from the pcb in the base into the sump and that seems all attached fine, it stayed on 19mins for about 5-10mins, then moved on and completed the cycle ok? strange
Re: WT640G 804100316 (53973) Which Tub Assy?
Ok mate thanks, i’ll go with that then.
Just in my own head How can it be a 6kg drum (which it states) for a 7kg machine? Bit of a fib on hotpoints behalf isnt it?Re: WT640G 804100316 (53973) Which Tub Assy?
Yep, that what I wad told too, that’s defo a 6kg drum assy though and it’s definitely a 7kg machine, I’m stumped. Lol
Re: VTD60P Power Board?
Power going to that board but no further – no power to top board – wont turn on
Re: VTD60P Power Board?
No that’s fine Jim, it’s not in the best of shape at all to be honest so they’re going to get a new one. Thanks though.
Re: VTD60P Power Board?
okey dokey, Sounds like a bit a fair bit of hassle. lol. Thanks for your help though mate. Much appreciated.
Re: VTD60P Power Board?
Is there a number on anything on the old board that would help me get the right one? or is looking a bit pot luck time again? lol
Re: CTD40G Tumble dryer element.
ive just seen a pic of the later element kit you mention Jim and it has 3 stats on it yet the machine in question has 2 (one of which is white, also i know cable coulours can change and its not alot to go by but there’s no white cable going into the connector block either on this old element).
Re: CTD40G Tumble dryer element.
Thanks Jim. Top stuff mate, How did you work that out mate? – i always get stuck on date codes like that.
Re: Zanussi ZWD16270W Wierd Fault,
Thats defo the 10th position, Is there a way to clear it? and try it again? to see if it comes up with the same.
All the wiring and connections seem fine so is it likely to be the main board would you think?Re: Zanussi ZWD16270W Wierd Fault,
Thanks, do that shortly,
Just put it through a wash, Seems to have gone through ok but went to it and it was defo washing fine, water was hot etc, left it a while and went back when i expected it to be no too far off the end and was still rinsing with 1 min on the display, It did shortly after drain out and spin out for 5 mins or so then finished ok (but done all that displaying 1 min). Seems the timers all over the show,
I’ll be back with last fault code etc.
Thanks
