Forum Replies Created
-
Posts
-
Re: Hotpoint wf740
Hi timdowning thank you for the quick reply you were spot on the brushes needed replacing the machine is now working fine ,I should of checked the
brushes but i have never known a wf to last long enough to wear the brushes out .Thanks again .Re: Fill Hoses ?!? American top loader
We had the same problem a few years ago phoned whirlpool up with the
model number and they posted two adaptors free of charge .We were
quite suprised .Re: L.G Pump
No it starts pumping fine then the display reads program end , and
there is still water in the machine .From pressing the start button ( with the program set to drain )to the display showing program end is less than
30 seconds .Re: Hotpoint AQGD 169S
Thank you for your fast reply , The machine is only 14 months old and
has i have no expieriance of this machine i decided to pass the job over ,Best Wishes Billy
Re: Raw and Working Appliances
We are always looking for raw washing machines to purchase .Will
travel 20 mile radius of St Helens Merseyside .You can contact me
at laundryman24@yahoo.co.uk or mobile 07528 647044Re: Currys Exchanges
Scrap washing machines (light iron) Are worth £170 a ton at the scrap
yards . EMR is the largest .Re: Supplier of new machines
neilsukwg wrote:What area do you live in?
Thanks for replying , our area is St Helens Merseyside
Re: Hotpoint – Change the bearings.
The back half of the tub needs to be changed on the wma series .they
cost £65/£70 and come complete with bearings and seal fitted .
The reason the bearings fail on the early wma machines is because the
drain hole between the seal and the front bearing was drilled in the wrong
position , It was drilled after the bearing not before the bearing so any
water that got passed the seal went through the bearing instead of escaping down the drain hole . Clear ? . The new tubs are light blue .Old
tubs standard grey /white .
