Forum Replies Created
-
Posts
-
Re: Zanussi Oven Keeps On Heating!
I’ve had this main power board heater relays sticks so new power board.
Re: Zanussi FL-1084
I had one like that it turned out to be blocked air chamber on the manifold, as the motor control goes through the pressure switch, cleared the pressure hose and the machine would then go into full spin
Re: AEG INT D/W F88070VI fault code i60
did one last week turned out to be the PCB in the base, heater relay stuck, as soon as powered up you can hear the water boiling in the heater.
Re: Thinking of moving to Spain ?
Hi I can confirm that mark has one engineer “me” still look for another as lots of work here, its silly seasons at the moment lots of holiday lets so first call 9am no siesta finish anywhere around 4 to 8pm, brands are fagor, edesa, electrolux, bosch, balay, aeg.
Re: AEG favorit 86070VI dishwasher
HI Tubs
I’ve got the same machine at home and it had same fault changed upper basket spray arm and now fine, I think that wear made it loose and was hitting the under side of the basket
Re: Wirlpool AWO/D 4505 – Fault code?
Hi I’ve got to go back to one of those, customer reports service light on and clean pump light on, door locked with water still in it. I rebuilt new tub and ran it in the workshop worked ok – any ideas ?
Re: elux ewx14440w
had a few like that, fault is on the dryer side could be the small dryer pcb behind the main pcb on righthand side
Re: Electrolux EWX14440W integrated washer dryer wont start.
can you get into the diagnostic system to read any fault codes. I’ve had this and its turned out to be the small dryer board behind the main pcb on the righthand side.
Re: Zanussi zwf1221w 914521001/01
sounds like the board and door lock, had an engineer who always did both on those models, but it’s down to £ ?
