sandysuds

Forum Replies Created

Viewing 15 posts - 46 through 60 (of 68 total)
1 2 3 4 5
  • Author
    Posts
  • October 19, 2008 at 4:23 pm in reply to: Hotpoint wm31 cuts out #265791
    sandysuds
    Participant

    Re: Hotpoint wm31 cuts out

    its a wma 31p

    July 17, 2008 at 3:45 pm in reply to: siemens siwathern 7902 tumble dryer #255881
    sandysuds
    Participant

    Re: siemens siwathern 7902 tumble dryer

    Hi guys
    This dryer is still giving me a headache, when started laundry dry stays on then the dryer goes for about 3 mins and then goes to zero and bleeps , i have checked heating side ok. can anyone help

    October 25, 2007 at 11:13 pm in reply to: tecnik dishwasher tkd 795/3 #230990
    sandysuds
    Participant

    Re: tecnik dishwasher tkd 795/3

    Thanks for your help andy that did the job

    September 19, 2007 at 5:12 pm in reply to: hotpoint wma 30 #228006
    sandysuds
    Participant

    Re: hotpoint wma 30

    it,s sandysuds@btopenworld.com
    Thank,s martin

    August 16, 2007 at 4:01 pm in reply to: hoover h110m( no power) #224717
    sandysuds
    Participant

    Re: hoover h110m( no power)

    hi guys thanks for all the help, But still no joy no power to machine,wiring ok, on/of switch ok, interlock ok, suppressor ok,,main,s ok, sent pbc to emw , no fault found, It,s a head scratcher.

    July 13, 2007 at 11:22 pm in reply to: dodgy zanussi FJ1354S #220531
    sandysuds
    Participant

    Re: dodgy zanussi FJ1354S

    thank,s for all help and advice guy,s,But it workrd for 1 wash and is away again ,start light flashing after a minute

    July 10, 2007 at 10:18 pm in reply to: dodgy zanussi FJ1354S #220529
    sandysuds
    Participant

    Re: dodgy zanussi FJ1354S

    i should have explained this a bit better, its the zanussi with the pbc on the top right hand side , i switch on ,select a program,press start delay button and it will do a full wash ,or 2 or3, then i will switch on select a program ,press start/delay will start for a minute, then the start delay light flashes,dont want to buy a new pbc ,as it may not be that can anyone help

    July 10, 2007 at 3:44 pm in reply to: dodgy zanussi FJ1354S #220528
    sandysuds
    Participant

    Re: dodgy zanussi FJ1354S

    thanks for the reply martin, the start button flashes and the reset ,no i dont have a disc

    March 24, 2007 at 1:41 pm in reply to: diplomat adp8132 #208757
    sandysuds
    Participant

    Re: diplomat adp8132

    thank,s for your reply but should i get a reading across them both and do you stock them

    March 19, 2007 at 4:53 pm in reply to: ariston margarita a1635 #206924
    sandysuds
    Participant

    Re: ariston margarita a1635

    QER tested the module and said no fault was found ,it cost £25 .40.to find that out

    March 14, 2007 at 11:48 pm in reply to: ariston margarita a1635 #206920
    sandysuds
    Participant

    Re: ariston margarita a1635

    thanks for all your help guy,s but im still nowhere, i sent the board away for testing ,no faults found ,tried a new motor still the same It fill,s up and the motor turns 3 or 4 times very weakly, and thats with the belt off,but it spins on the spin cycle .,i will give it one last try this week, HAS ANYONE ANY SUGGESTIONS

    March 8, 2007 at 1:35 am in reply to: ariston margarita a1635 #206919
    sandysuds
    Participant

    Re: ariston margarita a1635

    THANKS FOR REPLY CHRIS, IT TURNS SLOWLEY A COUPLE OF TIMES THEN BUZZES

    March 8, 2007 at 1:11 am in reply to: ariston margarita a1635 #206917
    sandysuds
    Participant

    Re: ariston margarita a1635

    thank,s for your reply baron, i tried it empty

    February 18, 2007 at 7:16 pm in reply to: ariston a1636 #204748
    sandysuds
    Participant

    Re: ariston a1636

    thanks for reply baron, its the rapid wash light thats on bottom of second column

    January 16, 2007 at 5:24 pm in reply to: diplomat adp8322 #198514
    sandysuds
    Participant

    Re: diplomat adp8322

    thank,s Chris, you were spot on

  • Author
    Posts
Viewing 15 posts - 46 through 60 (of 68 total)
1 2 3 4 5