The Equalizer

Forum Replies Created

Viewing 6 posts - 76 through 81 (of 81 total)
  • Author
    Posts
  • in reply to: Tricity bendix DH101. New IWMS System needed. #240258
    The Equalizer
    Participant

    Re: Tricity bendix DH101. New IWMS System needed.

    Well I’m extremely dissapointed to say the least.

    I spent all afternoon fitting this IWMS, & once its done, the Dishwasher is behaving almost as it was before I did the job.

    It starts loading water begins to wash, & when it comes to a second wash it just starts humming & does nothing.

    GUTTED!

    Any help anyone please.

    Thanks

    E

    in reply to: Tricity bendix DH101. New IWMS System needed. #240257
    The Equalizer
    Participant

    Re: Tricity bendix DH101. New IWMS System needed.

    Machine is up & running, of a fashion that it.

    It started drawing in water, & began to wash, but did not complete the cycle properly.

    Do I have to fill up the IWMS system manually for the first time? from the top where the piece of sponge is or does it do it automatically on first fill up?

    Anything else I should know good peeps?

    Thanks

    E

    in reply to: Tricity bendix DH101. New IWMS System needed. #240256
    The Equalizer
    Participant

    Re: Tricity bendix DH101. New IWMS System needed.

    IWMS Unit is now off.

    & I am getting the new one in.

    I hope this post helps some other newbie somewhere.

    Ok new IWMS is now in, just connecting up all pipework, before I put the sides back on & get it up & running.

    Will post next once i have got it up & running.

    Regards

    E

    in reply to: Tricity bendix DH101. New IWMS System needed. #240255
    The Equalizer
    Participant

    Re: Tricity bendix DH101. New IWMS System needed.

    Hi All

    I got the side off. & have disconnected the water inlet valve form the pipe work.
    It looks like i have to lift the IWMS unit out before I can get to the pipework attached to it. Is this right?

    Also I can’t seem to get the iwms unit free of the small round plastic vent that connects it to the inside of the dishwasher.


    OK Just found out that the plastic vent thing holding the IWMS on is a screw fit. it unscrews from inside the dishwasher.

    I also found out that by removing a small galvanised panel at the front of the dishwasher, underneath the door, I can access the pipework.

    So far so good.
    Any help please.

    Thanks
    E

    in reply to: Tricity bendix DH101. New IWMS System needed. #240254
    The Equalizer
    Participant

    Re: Tricity bendix DH101. New IWMS System needed.

    Hi Good folk

    I got the IWMS for my DH101.

    The time has come. I am now going to replace it.

    Are there any tutorials about, or if anyone has any advice before I proceed, It would be much appreciated.

    Thanks

    E

    in reply to: Tricity bendix DH101. New IWMS System needed. #240253
    The Equalizer
    Participant

    Re: Tricity bendix DH101. New IWMS System needed.

    Cheers penguin45.

    The advice is much appreciated.

    An email is on its way.

    Regards

    E

Viewing 6 posts - 76 through 81 (of 81 total)