[wellsm122]

Re: zanussi zwg6161

ran diagnostics and on every option the machine starts to fill with
water but does not post any error codes

[wellsm122]

Re: zanussi zwg6161

checked brushes both look ok, machine is only 18 months old,
prod 914906416, could it be the pcb, nbot worth changing or should i go for a cheaper part first……!

[wellsm122]

Re: zanussi zwg6161

yes on spin cycle fills then stops or with water in drum, programe ends after a few seconds.will check brushes tomorrow as working lates today

[wellsm122]

Re: zanussi zwg6161

thanks Gavin, tried the reset but still the same fault drain pump noise for 1 or 2 seconds then starts to fill. whilst is was working on the machine I tested the drain pump, 238 ohm, is the ok or a little high, also measured the voltable on the connectors when on drain cycle, 1 or 2 seconds at 240v but the is all over the place, so would your recommend pump or pressure switch and anything else……..
cheers

[wellsm122]

Re: zanussi fr1250 914516007

Great is there part number I can order, unable to find it on the parts site

[wellsm122]

Re: buy or repair, is it worth it !

thanks for the update, tested with tabs removed from heater element
have ordered part await delivery, will update once fitted.
any tips on replacing, as looks like you have to do a complete strip down !

[wellsm122]

Re: buy or repair, is it worth it !

thanks Peter for your reply
interestingly I had to tip out some water from the base
a couple of months ago
although no problems since then

[wellsm122]

Re: indesit WIXL123

thanks for the quick up date, thought it might be brushes,

machine drains ok

light1 flashes slowly

not in the trade, just help out family and friends

are brushes available from this web site
couldn’t find them

cheers

[wellsm122]

Re: Zanussi 91191511000

diag down to heater
what’s the best way to remove heater
from the bottom or remove side panels ?
cheers

[wellsm122]

Re: aeg lavamat 72630 fault

left over night, now started working but back to original problem
stopping mid-cycle with error e20

suspect pump although all looks ok when inspected……….
any suggestion.
also how easy to replace ? from front or rear of machine
would be greatful for any info……. cheers

[Author]

Posts