Forum Replies Created
-
Posts
-
Re: Hotpoint’s not draining
when the ntc fault occurs the pump runs for about 2 seconds then cuts off, reset and try again it will again run for 2 seconds etc
if you have a linear pressure switch or software issue then the pump wouldn’t run at all as the machine thinks its empty( even tho its not)
Re: Hotpoint’s not draining
guys I’ve had this a few times on the washer dryers believe it or not its a faulty dryer ntc or ntc wiring 🙂
don’t ask me why 🙂
Re: Hpoint Cker HUE61G Grill Light On Wen Top Oven Temp Sele
iirc these ovens have a door microswitch its on one of the side walls, when door is opened grill is selected with door closed top oven is selected
this could be faulty i.e. stuck in grill position or its moved so it thinks the door is always open.
Re: INDUSTRY STANDARD WAGE ?
when i was an apprentice out on my own doing calls i was on around £200 a week, granted this was 15 years ago but at the time it was a good wage, i was also on a bonus which i was very happy with, basically i got 10{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of what i earned after a certain amount, usually worked out about £50 a week but was a great incentive to drive me on.
if your lad is doing indesit work etc then it might not work out this way but id defo recommend some form of bonus e.g. right first time or something.
Re: Hotpoint c367ewh Facia
with most hotpoint cookers you remove the knobs and timer buttons, open grill door and remove 2 screws going upwards holding facia in place, the entire facia panel then slides to the left and disengages.
HTH
Kevin
Re: hotpoint bhwm 129
according to manual door led is 1, end is 2, drain is 3 spin is 4 and rinse is 5, the top light is not used.
can’t find any reference to the wash light flashing?? does it not just flash while it is on the wash phase?
hope this helps
Kevin
Re: Indesit IDVA735 vented dryer noise?
rear bearing rubbed through,
drum shaft now rubbing on metal back panel.
take off inspection cover, loads of black carbon will be giveaway 🙂
Re: Diplomat ADP8352 Diagnostic Help please
insualation fault on motor, probably wet, give it a blast with a hair dryer 🙂
Re: hotpoint wmud 1043
the blue coloured pressure switches are called linear pressure switches, they are an absolute nightmare to reset the link posted above does solve the problem but it takes patience and perserverance 🙁
motor faults or faults with wiring at/around motor can also cause funny faults
1 other cracker i came across is a broken wire at the dryer ntc causing a no drain!! dont ask me why tho 🙂
