admin

Forum Replies Created

Viewing 15 posts - 2,236 through 2,250 (of 12,518 total)
  • Author
    Posts
  • in reply to: Bosch Dishwasher SGS43CO2GB/35 #371070
    admin
    Keymaster

    Bosch Dishwasher SGS43CO2GB/35

    Yes. There is a tick box at the bottom when you post your item.that will then send you a e mail for each reply. You can go back into your post and edit it and tick if you haven’t done it.

    Bryan

    in reply to: Bosch WTB76556GB/05 #365157
    admin
    Keymaster

    Re: Bosch WTB76556GB/05

    Went to one of these yesterday doing the same fault as this one ,
    fault was the 12vdc relay on the board its sticking on ,its not the relay on pos k5 on the board its the other one (only 2 relays on the board)

    Canufixit

    in reply to: Samsung Sr s2028cvw #371101
    admin
    Keymaster

    Re: Samsung Sr s2028cvw

    Yep

    in reply to: Hoover spares #371096
    admin
    Keymaster

    Re: Hoover spares

    41002985 Defrostin.heating element Ransom spares have it £37 will find to if there is a better price tomorrow.

    Bryan

    in reply to: cellus washer #370816
    admin
    Keymaster

    cellus washer

    Doubtful if they will supply one though.

    Bryan

    in reply to: Guarantee #371117
    admin
    Keymaster

    Guarantee

    Hi

    In law.. It’s your responsibility at the end of the day as the seller. Warranty was being arranged through the WTA members to carry out the work .

    Bryan

    in reply to: Hoover spares #371095
    admin
    Keymaster

    Re: Hoover spares

    On hoover / candy ALLWAYS get the full serial number as the first part is the product code. but I will have a look for the part number.

    Bryan

    in reply to: Samsung Sr s2028cvw #371099
    admin
    Keymaster

    Re: Samsung Sr s2028cvw

    Probably condensation damage to the front PCB, Try to remove and clean up the contacts on the board and multi plug on the cable.Also make sure the buttons aren’t sticking in.

    Bryan

    in reply to: Hoover spares #371093
    admin
    Keymaster

    Re: Hoover spares

    Both are connect.. one e-spares,owned by connect I believe .

    What part are you needing ?

    Bryan

    in reply to: hotpoint FDW60 dishes wet after cycle finishes #371038
    admin
    Keymaster

    hotpoint FDW60 dishes wet after cycle finishes

    Hi

    After you start it. Have a look at the rear pipe work that goes up the back.. Is the water fully going up there?. If not put a extra 1 1/2 Ltrs of water into the dishwasher and check again. This is either the haier or midia machine and it’s a common fault and there is a modified pressure switch for this .

    in reply to: lg want report for d/drive #370959
    admin
    Keymaster

    Re: lg want report for d/drive

    Hi

    Normal practice.At least your’ll get paid to fit them without having to cover the warranty on the parts.

    Bryan

    in reply to: Capacitor Discharge Leads – for Microwave use #370890
    admin
    Keymaster

    Re: Capacitor Discharge Leads – for Microwave use

    I still say a wet finger is the best way.. :mrgreen:

    Checks that it’s holding power also. :rolls:

    Saves going for a 10 mile run as it’ll increase your heart rate without having to get changed… :clown:

    Bryan

    in reply to: Whirlpool Top Loader Pump Part Required Urgently #370875
    admin
    Keymaster

    Whirlpool Top Loader Pump Part Required Urgently

    Yep,a whole washer.was about 4yrs old but now about 7years old.kept it but nobodies ever asked for one.. Lol

    in reply to: Whirlpool Top Loader Pump Part Required Urgently #370873
    admin
    Keymaster

    Re: Whirlpool Top Loader Pump Part Required Urgently

    I have a complete one for sale in the garage.

    Bryan

    in reply to: Capacitor Discharge Leads – for Microwave use #370883
    admin
    Keymaster

    Re: Capacitor Discharge Leads – for Microwave use

    long nose pliers’..lol Or a wet finger

Viewing 15 posts - 2,236 through 2,250 (of 12,518 total)