admin

Forum Replies Created

Viewing 15 posts - 3,496 through 3,510 (of 12,518 total)
  • Author
    Posts
  • in reply to: Lofra PUD66MFE/CIN #308129
    admin
    Keymaster

    Re: Lofra PUD66MFE/CIN

    hi swerve

    zanussi 2 turn is the same one if i remember correctly,its not a obtruse one anyway.

    bryan

    in reply to: Sebo – Upright or Cylinder? #308022
    admin
    Keymaster

    Re: Sebo – Upright or Cylinder?

    Thanks Don :tup:

    in reply to: snowed in !!! #307975
    admin
    Keymaster

    Re: snowed in !!!

    Done all our calls except the rurals yesterday between the vans and my xc90.

    left this morning at 5.30 -7.5 took 30 mins to defrost the van,when to stop at traffic lights and carried on through…luckilly no other idiot about only doin about 10mph next roundabout…straight over..

    Fu{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}^G&^{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} luton council havent bothered to grit any of the roads again !!! all my calls cancelled,willwait till later to see if i pull the other vans off the road..better to back up the calls and keep the vans than to let the other idiots smash them up.

    bryan

    in reply to: Sebo – Upright or Cylinder? #308020
    admin
    Keymaster

    Re: Sebo – Upright or Cylinder?

    One other random question.
    Any idea roughly what the reach is of the shorter attached hose?
    Gary

    in reply to: Sebo – Upright or Cylinder? #308019
    admin
    Keymaster

    Re: Sebo – Upright or Cylinder?

    OK. Thanks both again.
    Just reread this thread which I notice gives a lot of the info I was after 😳

    Think the only thing I really need to consider is the stair cleaning but sounds like the X4 Extra would be OK with the longer included hose.

    Gary

    in reply to: Sebo – Upright or Cylinder? #308016
    admin
    Keymaster

    Re: Sebo – Upright or Cylinder?

    Thanks both for the replies.
    Just read your review Ken. Sounds like there is not too much in it apart from cost, assuming both will be reliable. Just preference.
    I’ll discuss it with the boss 🙂

    Is there any advantage in going for the commercial models? I see Oliver that you’ve mentioned that they might be a bit too harsh for domestic use. Do they offer any advantages? Not sure if they also have the 5 year warranty?

    Ken.
    Do you have the X4 Extra’s in stock? Wasn’t sure when looking at the shop page message. Assume the K3’s are in stock?
    Washer and dryer still doing a sterling job by the way. Only been 2 years though. Will be holding you to the next 18 😉

    Gary

    in reply to: HMRC Christmas Card #307022
    admin
    Keymaster

    mine came through at £5k 🙁 and i earn less then my engineers ..(working on an hourly rate that is)… something is very very wrong

    in reply to: ROSSAIRE 2040dbuk #306845
    admin
    Keymaster

    no all other numbers worn away as cooker is 15+ years old

    in reply to: hoover optima oph714d #306603
    admin
    Keymaster

    Re: hoover optima oph714d

    HI, E03 IS BLOCKED PUMP, E16 IS O/C HEATER

    in reply to: Whirlpool fridge freezer fault codes please #306480
    admin
    Keymaster

    thanks

    in reply to: is this right? #306448
    admin
    Keymaster

    Re: is this right?

    LOOKS LIKE SIMPLE SIMON IS LOOKING FOR THE SIMPLE MINDED :rolls:

    canufixit

    in reply to: Supplier of Captive nuts #305947
    admin
    Keymaster

    Re: Supplier of Captive nuts

    ford dealers also keep them in stock pkts of 15 if i remeber from this afternoon

    bryan

    in reply to: Whitegoods v’s Osama Bin Laden? #305950
    admin
    Keymaster

    Re: Whitegoods v’s Osama Bin Laden?

    Hi Martin

    Could you confirm weither or not you are sitting close to him at the same time. ?

    Bryan

    in reply to: Baumatic BDW9 #305762
    admin
    Keymaster

    Re: Baumatic BDW9

    Nah not in a BDW9 its in front behind panel…..also has pressure switch to top up in front on r/h side pull hose off pressure switch and blow through it….may solve the problem….but will E1 if takes too long to fill

    in reply to: miele t650c heater stat ….170c… #305724
    admin
    Keymaster

    Re: miele t650c heater stat ….170c…

    Thank you kind sirs……. 😀

    was no TNR number on it chris ❓


    canufixit

Viewing 15 posts - 3,496 through 3,510 (of 12,518 total)