Forum Replies Created
-
Posts
-
I had this the other day and found the motor juddering.I wonder what caused the pcb error and found the hose at the top of the dispenser had come off and had leaked onto the motor changed the pcb and alls well.PS allways ask yourself why the pcb blew in the fisrt place before changing
IF you are getting various faults i suspect possible loose connections on the pcb they normally come loose and give random error codes
Had this can be a few things if the motor brushes ok and the pumps fine ,check the pcb connections normally they work loose and can cause this,Not normally the timer
Well the next time i have a customer that says whats a good hoover to buy i will tell her to avoid Vax Word of mouth goes a long way. If we all kept to the good companys the bad ones will get the mesg if its in their pocket
sometimes the element can be low on insulation can cause spin problems strange but true on hoovers.Did you check it
Sorry should of stated Dave fridge.Its a small under work top one.Not to good on thermostat so i tend to use the original if i can .Open to suggestions anything goes to fix it
you’ll probably get a recall later .Once had a lady who used washing up liquid in her dw.And still complained about it going wrong. I like some of these big cups you get in the powder boxes looks like a mcdonalds extra value coke cup
sounds like the pcb is iffy if the motor meters ok and the tacho is fine can only be the board.If tach was loose the motor would probably go straight into a spin or on the wash programme would spin again fast
Silicone grease on connect part no sg2 excellent and if any goes on the drum then to clothes hard to spot.You dont get the blame for black grease after bearing change I also use the zanussi lube on all the bearing changes
