Forum Replies Created
-
Posts
-
You can spend ages on Dysons taking them apart.The best part is trying to put all the plastic back together.Easy to fix hours to get into
Yep dont muck around you may as well take the units shell of if you havent done it before or been shown youll struggle,I normally take the top shell of and fill the white bowl up you will then see the fault may be grime on the seals if you look for short cuts it may take longer i agree with Martin on this one good luck.
On this model i have had several of these faults and normaly find the pump struggling Due to the board you have to replace both pump and board or it nocks the pump out again
Yep a lot of models struggle with this .I also run a piece of wire down the hole seems to work .But i do wonder why the main manf dont do it although i have seen a unit with the element going down the hole.
Good way to check the tubing fill the sink with water hold one end and dont get carried away blow till ya harts content. Ive had this and just cleaned the tubing and sump did’nt get a call back ages ago now
Yep im on about 70 takes me 30 mins max with cup of tea now best way just rip all the old wiring out and start from scratch remember to leave the ignition wires in place .It is a straight forward job watch out when cutting wires dont hit the thermostat phial i speak from experiance on that.Make sure you do replace the wiring or youll be back for a recall whithin a month
Aqualecctric LG have modify the dispenser the holes in the top are different .Took a long time though.
A good excuse i always say is im green I dont wash me van cause a water bans on. A KIRK Will agree Once every three months is enough any longer and i can sighn wright it for free
hi see my post its on the side by side samsung may help
you no your samsungs then.I will pass all this info on to my friend hope he gets on ok with it.And its helped me to.I’m beginning to see a lot more samsung stuff myself.Are they prone to leaks .I’ve had a couple of standard units with very little gas in Vacumed down and find slight leaks .
I will see if he has checked the elements if they are ok then may be fridge sensor or defrost timer he’s already changed the module . Is the defrost built into the module? if it is then must be a probe Cheers Flyman
The best pliers i bought cost 1 quid from folkestone maket and have never found another pair like them may have to try this one heaven forbid i loose my pricless pliers
Another problem was the fan motor near the comp should be on when comp running.If not comp overheats can cause fridge problems had a few
