[Alanj]

Re: CDA cooker CD251SS wiring diagram

Hi Pigpen, have sent you an e-mail.

Alan

[Alanj]

Re: ID Card Idea

Hi Ken,
my WTA member card expired August 2009, when will I get a new one?

Alan

[Alanj]

Re: ISE website

Hi Ken, my landline is listed twice, listed web address is actually my
e-mail address.
Correct details are: http://www.applianceservicesbanff.co.uk
e-mail Alan@applianceservices.wanadoo.co.uk

Can you update these please Ken?

Thank you

Alan

[Alanj]

Re: Zanussi ZKT631DX E3 fault

Cheers Victor, will check it out.

Alan

[Alanj]

Re: Hotpoint WML520P

Thank you Jim. 😀

Alan

[Alanj]

Re: Masterpart Again.

me too waters £40.14, but Connect £5.45 or 2+ £5.08. Must be a mistake at Masterpart ❓ ❗

[Alanj]

Re: Indesit SAN300UK (34532)

this one is freezing contents of fridge.

Alan

[Alanj]

Re: Zanussi Sole motor

Hi George, Masterpart Part No. UN12103 (£7.99 set) or Connect CBN9041
(£13.40 set). HTH. 🙂

Alan

[Alanj]

Re: Indesit SAN300UK (34532)

Problem solved Live to 6 and compressor to 4 (2). Stuck phial in freezer and tested operation. 😀

Alan

[Alanj]

Re: Indesit SAN300UK (34532)

Hi Simon,
what are the connections for compressor using only 2 of the three terminals 6 and 4? Terminal 3 not required?

Alan

[Alanj]

Re: Indesit SAN300UK (34532)

I would assume that if terminal 3 is for switching the light off then 1 and 2 would be the connections? 😕

Alan

[Alanj]

Re: SMEG DI612C

E2 – Safety pressostat intervention
This alarm is generated when the safety level (PRS1) intervenes, both when there is or there is not
the full tank signal (PL0). In this situation the programme is not immediately stopped, but however
the tank is emptied and then filled. The water quantity, in this case, is decreased.
This situation can happen max 3 times consecutively in a washing programme, after these 3 times
the programme stops signalling the anomaly.
This defect can be caused by:
– defective pressostat level
– difficulty to connect the pump or faulty washing pump
– water in the safety pressostat pipe
– filling solenoid valve with high flow rate
– electronic card which does not read the “full” signal

[Alanj]

Re: SMEG DI612C

Hi Robbo,
fault is E2 water safety valve activated.

HTH Alan

[Alanj]

Re: Indesit SAN300UK (34532)

Can any one help with this problem?

Alan

[Alanj]

Re: Indesit SAN300UK (34532)

SAN300UKZ not listed on Connect or Masterpart?

Alan

[Author]

Posts