Forum Replies Created
-
Posts
-
Re: Indesit SAN300UK (34532)
Jim here is all numbers off inside of machine at back of salad bin.
IND 76 34532 7600
S/N608300029
SAN300UKAlan
Re: Indesit SAN300UK (34532)
also there is no Z listed on the appliance but the 34532 is quoted on connect when looking up indesit appliances.
Alan
Re: Indesit SAN300UK (34532)
Hi Jim, I have tried inputting that number into Connections but it still comes up with three term stat. Masterpart comes up with part number
C00141230 but no picture and if you input this number to Connect it comes up with 3 term stat.Alan
Re: Siemens EH785502E/09
Had a closer look at this hob today and dismantled to access electronic boards. There is a track on the board blown. I tried soldering a link accross, the ring back left worked ok but when I tried the front ring the error “e” came up again and both rings don’t work again.I assume the repair didn’t hold. Is it possible there is a fault with the front ring which has blown track on board?
Alan
Re: Siemens EH785502E/09
Hi Guys, any Bosch/Siemens experts out there, I have been to this induction hob and the 2 right hand rings(same size) don’t come on at all. The controls light up and will go to 0 but then this “e” starts flashing. Hand book does not show this fault but says that any display with “Er” is related to electronics failure. Any Ideas please?
Alan
Re: Carbon Brushes for a 13 month old Zanussi Washer
Hi Malc, also available from Masterpart UN12103 for £7.99+vat a pair.
Alan
Re: Neff R4381X1GB Condenser dryer
Hi Guys,
if there are no blockages where do you look next? Is there a sensor of some kind that detects blockages? Where is it situated?Alan
Re: AW23 showing E32 & E35
Hi Jim,
had one the other week. Turned out to be a broken wire just at the spade connection on the heater. 😯Alan
Re: Bosch Classix W/M
Hi Martin, I did see the post just below mine about fault F00, so I followed the procedure you posted there. Machine up and running again, so thank you again. Alan
Re: hotoint ctd40 very noisey
Hi Ed, sometimes the rear fan shears on the shaft of the motor. Fan looks ok until you turn it by hand and find it’s loose. New fan and it’s sorted 😉 .
Alan
Re: AW23 soap hose
Hi Guys, I too have had a few of these rubbed through hoses. Since reading the fix, with the spring, I have been to three machines with this problem and have to say that stretching the spring does work. However it is easy to over stretch it 🙁 . Might be worth having a stock of spare springs 💡 ?
Alan
