Forum Replies Created
-
Posts
-
Re: Hoover Oph7174D E03 fault help please
Can i not just test with my insulation tester rather than trying to run it with the heater disconnected ? 😕
Re: Hoover Oph7174D E03 fault help please
Already checked the usual suspects, which connector was burnt out ? Im thinking pressure switch may be the culprit on this one seems to wash ok & drain then E03 displayed.
I will meggar element though. 😕Re: Hoover Oph7174D E03 fault help please
I know this is an old thread but i would like to know how this turned out, i have a similar m/c doing exactly the same ?
Re: Zanussi ZWD 12270S
I would be gratefull if any one can help me out on this or can i find the info on Mediater ?
Re: Interference suppression.
I’ve also bypassed mains filters in the past for short periods of time never had a problem. 8)
Re: Candy GO147 overheating.
Just got around to updating this thread, replaced thermistor and tested pluged into my energy monitor. Heater duly switched on and OFF in expected time. 😀
Re: Waste Carriers Licence
The powers that be are only concerened with dealing with the waste (and the money that can be made by some from it) rather than reducing the amount of waste produced. Rather like sticking a plaster over a festering sore !
Re: Waste Carriers Licence
I know for a fact some recons i have sold in the past have given 7-8 years service. I doubt a new hotpoint/ indesit will last that long !
Re: Waste Carriers Licence
So anyone reworking “graded” appliances would need a T11 including the manufacturer ?
Re: Candy GO147 overheating.
Been around to look at this, reading at 80k and strangely rising quite rapidly as i tested it even though thermistor still screwed to tub.
Connectors to board seem tight and no reports of fault codes, i don’t know if i should chance a new thermistor on it can’t see them being too pricey ?
