Forum Replies Created
-
Posts
-
Re: Hotpoint FDL570 filling not in use
Valve filter was clean, no water softener are required in this soft water area. I suspect valve is being fed when not in use from the board.
Allan
Re: Whirlpool 859204215010 heater replacement
Thanks, at least I know it’s the correct part. It is strange it pops out when I tighten the nut. I’ll go back and scratch my head :bang:
Allan
Re: Bosch WTS84516gb/13 belt change
Thanks Dave, wasn’t sure if I should strip front off or go in through back.
Allan
Re: Gorenje dishwasher GV60010 TOC
Thanks for replies, I’ll check the temp rating and waterflow to top arm
Allan
Re: Whirlpool ADG7560 854275515879 draining error
Thanks
Is the owi sensor to measure soiling of water ?Allan
Re: Whirlpool ADG7460 851144015881 faulty heater
I’ve fitted the heater conversion kit to this but heater is coming on all the time now.
I’m guessing a triac has popped on the module or could it be something else ?Allan
Re: Whirlpool ADG7460 851144015881 faulty heater
Thanks, I had a look online earlier and it does indeed look like a conversion to the flow through type.
AllanRe: Whirlpool ADP7409 851156115892 Fault F6
Checked thin wires to flow meter reading okay. There’s a third wire from the flow meter output on pcb going to a sensor on sump, fed off circ pump. Can anyone tell me if this could be problem ?
Allan
Re: Whirlpool ADP7409 851156115892 Fault F6
Nothing visable Dave. Protection sleave is intact, I’ll double check thin wires to flow meter with multimeter.
Allan
Re: Hotpoint’s not draining
My problem was dryer NTC on washer dryer Paul. Had the same problem a few times since posting.
Pump runs for a few seconds then cuts off, common fault it seems.Allan
