Forum Replies Created
-
AuthorPosts
-
Andy jones
ParticipantRe: LG F1480FD Can’t Find Minor leak
Have you peeled door seal back to check it properly ??
Andy jones
ParticipantRe: Ariel or Almat, Which is best?
I think we have to take the likes of aldi and lidl seriously. Their own brands are great value for money. As I’ve said we live very close to one of them and a lot of their stuff is much cheaper and a lot better than most of the other major supermarkets
Andy jones
ParticipantRe: Ariel or Almat, Which is best?
Out of interest what are most advising for white washes
Andy jones
ParticipantRe: Bosch Condensing Dryer : WTE86304GB/05 Steams Up
I know I’m stating the obvious but is the condenser definitely clean
Andy jones
ParticipantRe: Bosch Condensing Dryer : WTE86304GB/05 Steams Up
Certainly sounds like some sort of blockage
Andy jones
ParticipantRe: siemans sn25m831gb/03
Press and hold start button for about 10 seconds normally
Andy jones
ParticipantRe: Zanussi gas cooker makes a popping noise
My only advice would be to get a gas safety registered engineer to check it over
Andy jones
ParticipantRe: Indesit washing machine iwc6105
It could be if the board needs replacing. As said above it is an indesit 🙂
Andy jones
ParticipantRe: Indesit washing machine iwc6105
Sounds like the transformer buzzing
Andy jones
ParticipantRe: The Technophobe Inn
No chance of 4g here either. Well not on O2
Andy jones
ParticipantRe: The Technophobe Inn
My kind of pub 🙂
Andy jones
ParticipantRe: Bosch WTA4007GB/04 belt replacement
I’m sure that’s the model no after checking. I took fan off and fed belt through the hole then over the motor itself.
Andy jones
ParticipantRe: Hotpoint 9534A Rinse Hold Issue
Still service an 1850 style with the purple door. Still going strong after all these years. I replace brushes every couple of years and that’s about it
Andy jones
ParticipantRe: Bosch WTA4007GB/04 belt replacement
Have to admit I started to take the front off but realised it wasn’t going to get me far
Andy jones
ParticipantRe: Bosch WTA4007GB/04 belt replacement
Not sure if it was the same model but i managed to take the fan off and the support screws for the drum, fed the belt round the motor pulley and halfway round the drum then just turned the drum to get the belt all the way on. I then levered the drum up slightly to refit the drum fixing screws
-
AuthorPosts
