Forum Replies Created
-
Posts
-
Re: Whirlpool Top Loading Washer (3RLSQ8033SW0)
Thanks guys,
I’m not sure how I missed that as I had the control panel off and didn’t see it. I’ll head back and check.
Many thanks for all your help.
Mark
Re: Hoover DYN 8164D-80
Morning again guys,
I’m really struggling with this, I’ve tried a new module with no luck. Am I chasing my tail by overlooking things? Any help really would be appreciated.
Yours,
Mark
Re: Indesit KP 59 MS.C (X)/G Tangential Fan
Sorry to ask, can anyone help with this spare, I just can’t find a part number anywhere.
Mark
Re: Bosch WVTI2842GB/07
Hi Guys,
Thanks for the advice, I hadn’t pulled the machine out so will go from there and let you both know!
Mark
Re: AEG D4101-4-A Main Oven Door
The price is going down little by little, 4domex have it for £160ish. Has anyone any experience of them, I’ve only just come across their site.
Re: AEG D4101-4-A Main Oven Door
My excess is £500 as I’m a plumber as well as my appliance work, a real bugger I’m sure you’ll agree!
Re: Hotpoint WMM39A very short spin
Thanks for the advice, I did give the machine a good once over, the one issue I found was that a wire had rubbed on the concrete weight leaving it bare, I insulated this prior to running the machine, excuse my ignorance but could this have caused the issue, it hasn’t come into contact with any other bare wiring or metal.
Mark
Re: Hotpoint WMM39A very short spin
Been back and ran the test and it came back with a motor triac short circuit. I ran the machine more thoroughly than yesterday and found that during a wash cycle the drum turned extremely quickly, something I’d never experienced before (does that show a lack of experience?). Wiring appears to be fine and brushes new so it looks like a board fault.
Am I right in thinking this is the same board as shared by numerous WMM and WMA machines? What are your opinions in terms of repairing the machine, the customer has asked for my opinion relating to cost of repair over quality of machine.
Mark
Re: Hotpoint WMM39A very short spin
Bugger! I’d not realised that, looks like a trip back to the machine 🙁
Re: Hotpoint BFI260 Error
Thanks Jem, as it happened I suspected the high pressure sensor, this was removed, cleaned along with the attached hoses and replaced. What I couldn’t understand was the lack of heat, would this be common with a high pressure sensor fault?
Thanks for the details regarding the board, that looks of interest.
Mark
