UK Whitegoods

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 56 total)

1 2 3 4 →

Author

Posts
October 30, 2025 at 1:41 pm in reply to: Re: Bosch WTB84200GB/09 Series 8 Condenser tumble dryer #494052

ashfordkent
Participant

Thanks Dave, just a bit of a drive to get there. Just looked for a similar thinking of fault.

August 22, 2025 at 2:46 pm in reply to: Hotpoint Oven SA2540HWH error code F01 AND F24. #493494

ashfordkent
Participant

Follow up. I Got this In an email from customer: Whilst cooking the fault f01 appear on the display of the oven. Then a little while later F24 appears after. We then have switch the orange power switch off then the faults clear.

October 31, 2024 at 9:11 pm in reply to: Hotpoint slimline dishwasher code 5 #491615

ashfordkent
Participant

Was thinking this way maybe, ta Dave

November 5, 2023 at 11:46 pm in reply to: Bosch Washer Dryer error code C1n #488458

ashfordkent
Participant

Yeah I seen that give It a go, thanks Dave

November 20, 2022 at 12:50 am in reply to: re Hotpoint HUD61KS Dual Fuel stand alone cooker #484522

ashfordkent
Participant

Many thanks Dave for that

November 25, 2020 at 4:08 pm in reply to: Indesit DIF04B1UK Heater #473478

ashfordkent
Participant

ps New one on Right is a Few mm Smaller than Failed Part

October 15, 2020 at 6:38 pm in reply to: Fisher & Paykel OR90LDBGX1 fan motor and Element #472567

ashfordkent
Participant

Many thanks for your response’s

January 26, 2019 at 10:33 pm in reply to: Smeg Integrated Dishwasher Door Drops #460220

ashfordkent
Participant

Many thanks Dave for you’re help, quite a distance to call so want to go in with half a chance of completing repair. Peter

December 18, 2017 at 4:53 pm in reply to: Re Creda 48906 solar plus Hob #452435

ashfordkent
Participant

Re: Re Creda 48906 solar plus Hob

Thanks Dave and all at British Gas

December 13, 2017 at 9:57 am in reply to: Re Creda 48906 solar plus Hob #452323

ashfordkent
Participant

Re: Re Creda 48906 solar plus Hob

Thanks Iceman69 very much for that quick answer, have a good christmas

September 11, 2017 at 1:51 pm in reply to: Re Hotpoint DH93X #450335

ashfordkent
Participant

Re: Re Hotpoint DH93X

Thanks for reply, thought same myself just they’ve been using a timer on grill (i don’t know why) and saying ok b4 now intermittent not grilling. Will tell them if change parts no gtd it will work.

April 9, 2016 at 1:21 pm in reply to: Re Hotpoint DSC60S Stand Alone Cooker #436882

ashfordkent
Participant

Re: Re Hotpoint DSC60S Stand Alone Cooker

Thanks for reply. Problem is very small restrictive galley kitchen, so could only just get screws out to tilt lid up and have a look, and crawl over work top to look in back. you know what i mean! Thought its either Timer or selector switch on front of main oven thermostat so want to go back prepared for major surgery.

November 10, 2015 at 3:08 pm in reply to: HOTPOINT TCUD 97B 6PM (UK) F03 #432404

ashfordkent
Participant

Re: HOTPOINT TCUD 97B 6PM (UK) F03

THANKS FOR THAT. ITS DOING EXACTLY THE SAME AS IN THE VIDEO ON YOU TUBE. THIS IS THE SITE

https://www.youtube.com/watch?v=nUbfRkER0n8

July 8, 2011 at 8:49 am in reply to: Re Smeg A1 Dual Fuel range Cooker Fusing #354952

ashfordkent
Participant

Re: Re Smeg A1 Dual Fuel range Cooker Fusing

Sequence is switch on Cooker. Set timer, Select oven with Selector switch then Bangs and Trips large Flash from selector switch. Even with each item disconnected 1 by 1 still same result. Meggered each item comes up ok.

November 3, 2009 at 8:04 pm in reply to: re Ariston MBA3832VUK Dead #300615

ashfordkent
Participant

Re: re Ariston MBA3832VUK Dead

cheers twinspark, new module fitted now running,
Author

Posts

Viewing 15 posts - 1 through 15 (of 56 total)

1 2 3 4 →