Forum Replies Created
-
Posts
-
Re: Hotpoint WD 645 Various errors
I’ve checked the main board and cant see no ingress and looks in quite reasonable condition with no burnt or damaged tracks either… I also put my meter across the heater with a reading of 0.025 ohms is this correct? Regards .
Re: Hotpoint WD 645 Various errors
Sorry for the late reply .. I got it from my sister as she had a upgrade
I had a suggestion about the heater being faulty or the stat ? but cant see it myself thought id ask?
Re: Proline TDC7A
and im running both and still have this ??? but I will check the jockey wheel you mentioned but it did seem all fine when I gave it a inspection … off this thread are there any ppl that deal with the huebsch coin op models of dryer you know of
Re: Proline TDC7A
ive greased both jokey wwheels to no avail … ive now fitted the front plastic shim/bearers on the front and its still the same … tbh its worse since I posted the last post to present
Re: Proline TDC7A
Found the short circuit to be where the heater coil come through the insulating card and was fouling the chassis … all is good for now and I did clear the wet soggy fluff from the base .
What I’ve now found is the plastic/nylon bushes are missing from the front valance so I’ve ordered some of those, as said its working at the moment but with a heavy grumble when turning the opposite direction so lets hope this fixes this ?
Re: Proline TDC7A
Big thanks to IADOM the cap was the culprit … I replaced it with a 8uf capn … is this ok as the print had rubbed of the capacitor itself … I googled about and everywhere staited it was 8 uf… now however when I select full heat its tripping the electric, and cannot find the short with the heater to earth with the full heat switch on, is there something im missing ???
Re: wma 61 bearing size?
I’m aware of the strip down as i’ve done many but never knew a way of telling what bearing was needed till it was stripped !
The washing machine hasnt broke down for 8 years so im expecting the worst for spares on a whole but the bearing isnt showing 8 years … just a little play but me thinks it need shocks, springs, bearings and brushes and does NOT want to change the machine what the cost even though i told her it would need a total overhaul
Re: Candy CN 100 program selector dial not advancing
normaly a circular looking device with a pipe coming from the tub attached to it , as the washer filles with water the air pressure in thwe pipe increases operating this device remember to unplug from mains first and reseal the pipe as you risk a flooding if you dont!!
Re: Hotpoint Aqualtis AQGMD 129
Happy days, put it on a quickwash and it completed it so its now reinstalled to the kitchen to fight the pile of washin befofe it .. BIG thanks to the MADANGLER1 and BOB the beer’s on me guy’s thanks and what a great site guys.
Re: Hotpoint Aqualtis AQGMD 129
sorry that was an f3 error i got not f13 whith turned out to be the ntc(stat)in the tub as i didnt put the plug back on from testing yesterday so its back on test and so far so good
Re: Hotpoint Aqualtis AQGMD 129
Yes i had to split the dryer casing to remove the ntc , ive now replaced the ntc as it seemed the one i bought was faulty but now replaced its operational to a point, i put on a spin to test which takes 20 mins on the display , after 13 minutes im getting the f13 error again but it did run so now im testing it on a load hooked up to the water and ill opost back my findings .. hopfuly i will clear then i can clear this mini mount everest of clothes
Re: Hotpoint Aqualtis AQGMD 129
well ive been and got the replacement and its still the same , any other idea’s
