Forum Replies Created
-
Posts
-
Re: Hotpoint WMD960 F11
F11 is a pump disconnected error, check the wiring and pump for going open circuit before condeming the module.
Bob.
Re: Deawoo f/f FRS-U201A1 fans not working in freezer or fri
it will be the freezer evaporator fan motor that has failed, but if you want the service manual just PM me an email address.
Bob.
Re: Hotpoint AQXXL129P1
had quite a few of these with that problem every one was the moulded plug arcing internaly, cut of the plug rewired a new one and never had a recall.
Bob.
Re: indesit / hotpoint drum paddles
there is an offical mod for this problem, pm me an email address and i will send some info.
Bob.
Re: rapport
i have the same problem as drdill, and the FTP site link requires a username and password
Re: Hotpoint FF200EA lights flash.
the lights flash to warn the user there has been a power outage and to check the freezer contents are still frozen, to reset turn both temp dials to off for 10 seconds then back to the I care setting.
Bob.
Re: Hotpoint BU82SS Double Oven
31619, 54851, 45314, 58944, thats all of the commercial codes for that model, its on the rating plate just miss out the first two numbers on the rating plate and find the next 5 that match.
Bob.
Bob
Re: Hotpoint BU82SS Double Oven
hi John,
commercial code required for this one as there are a few mark 2+T+/2 models all have differant commercial codes.
Bob.
Re: John Lewis (Electrolux) JLAFFS2007 american style F/F
E and F relates to the freezer evaporator fan fault, it could be blocked with ice or faulty.
Bob.
Re: Plastic Outer Drum repair?
epoxy putty called Dr Dings is recomended by hotpoint, dont have the part no as the site is down at the moment, but it does work for holes up to 10mm max.
Bob.
Re: Capacitor Discharge Leads – for Microwave use
For the high voltage capacitor in a microwave oven, use a 100 K ohm 25 W or larger resistor with a clip lead to the metal chassis. The reason to use a large (high wattage) resistor is again not so much power dissipation as voltage hold off. You don’t want the HV zapping across the terminals of the resistor.and encase the resiator in heat shrink sleaving. Clip the ground wire to an unpainted spot on the chassis. Use the discharge probe on each side of the capacitor in turn for a second or two, Since the time constant RC is about .1 second, this should drain the charge quickly and safely
Bob.
