Forum Replies Created
-
Posts
-
Re: E430EW
is it part numbers you require or the parts.?.
C00224764 oven
C00224795 top oven
C00224798 GrillBob.
Re: Hoover Washer Dryer VHW656D – No sign of life
looks like you and the last owner have the same problem unprogrammed board.
i have sent you a PM.
Bob.
Re: Hoover Washer Dryer VHW656D – No sign of life
what was the part number on the box it came in and what was the part number from the place you bought it.
the board is not useless it just needs programmed, but the piece of kit to do it is priced out of the DIY market.
Bob.
Re: Hoover Washer Dryer VHW656D – No sign of life
the replacement coreboad comes in 2 versions 1 programmed ready to plug in and go and 1 unprogrammed blank for use by anyone who has a memloader to reprogramme the coreboad.
the numbers on the board mean nothing as they are all the same only the date code will change.Bob.
Re: Hoover Washer Dryer VHW656D – No sign of life
the part number for the programmed coreboard is 49018217.
Bob.
Re: Whirlpool American Fridge Freezer 858642215000
if its the water inlet valves its 481236058486.
Bob.
Re: Hoover Washer Dryer VHW656D – No sign of life
41028739 is a unprogrammed coreboard if you want the part number for the programmed coreboard i will need the seriel number of the appliance.
Bob.
Re: Hoover Washer Dryer VHW656D – No sign of life
was the module/pcb a programmed or unprogrammed board ?, what is the part number of the pcb you fitted.
Bob.
Re: hoover hnc170-80 motor parts modifications ???
looking at the service manual you have the wrong jockey pulleys the part you need is 06017597 X 2.
Bob.
Re: Indesit d61 D/W
its the same as a washing machine heater about 25 to 30 ohms if tested from the module.
Bob.
Re: Indesit IDV65 Dryer
drill out the rivits and fit the normal shaft kit into the pre drilled holes.
Bob.
Re: lg w/dryer
screws at the bottom and they may be 2 scews behind the facia if its a recent model
Bob.
Re: Indesit smart card programming
unplug appliance wait 5 mins, change module, plug in smartcard to reader, plug in reader to module then switch on the appliance at the plug/socket and pray it works first time if not try again until you get a green light on the reader, switch off at the socket remove reader and switch on to test, which smartcard and appliance commercial code do you have. ?.
Bob.
