Forum Replies Created
-
Posts
-
Re: DIPLOMAT APM 8703 WASHER/DRIER query
hi sounds like a leak to me. Shouldnt rinse in hot water, if it is an installation fault manufacturers repair agent MAY charge you for a call out get installer back to inspect.
cab
Re: Zan F1045W only 1 selection works properly
well…a little more info is required. does it wash but doesnt spin? does it not wash or spin? please try to give as much info as possible.
cab
Re: lux F/F problem
hope it works ok the reason I gave thestat type was its not unusual to get the wrong stat in the right bag if you get my drift!
cab
Re: lux F/F problem
Hi never come across a problem, unless it has got water in that has frozen.
the part no. I have is 2262199116 k59l2037 is the one you tried to fit the same?cab
Re: squeaky rangemaster,help me please do i need cheese??…
hi did one today back off, if in doubt!!!!!
cab
Re: New Bearing on Zanussi WDJ1294
I hope the drum shaft was in good condition or you might find the repair may only last a short while!
😳 cab
Re: AEG 50700-W Melted Dispenser solenoid operates permanent
hi dispenser no. 4071358131. module pre configured 1115730002 looking about £150 + vat for both.
I have sent you an email.
cab
Re: Baumatic BDW5 dishwasher flashing lights!!
hi is the stat at back centre and pokes thru tub between heater? If so these can fail if the customer is placing a large pan over it stopping the water getting around the heater at that point which causes localisation of heat tripping stat. There should be a seperate stat or ntc this is an overheat stat, one shot.
cab
Re: Zanussi ZWX1505w
might be signalling fault, buzzer should only come on at the end. buzzer can be turned off, press temperature and spin together (check instruction book)
cabRe: l.g bearings
hi, there are two tub types on LG, most are like Zanussi split plastic tubs, but comes out thru the front. but there are a few out there like a Beko, plastic tub and a tub front clipped on, if its this type you can get the drum out thru the front and knock the bearings out with tub in position, either way not too difficult a job.
cabRe: Why do they do that?
LG washers do it for me! how tight are those screws! f…… many a screwdriver and powerdriver bit.
cab
