Forum Replies Created
-
Posts
-
Re: Fitting Zanussi door seals
ditto….whats all the fuss about, being doing these for donkeys!, horses, goats…………….. 😆
Re: Zanussi ZWF1630W
user pcbs prone to failing E90/E91 code , vent steam hose can get damaged causing leak onto boards also
cab
Re: zan1415w wont start
most common fault on these are the drain pump, after locking the door should go into drain, if pump goes down to earth will blow board.
cab
Re: Electrolux ESL6114 d/w
not the iwms modification to the fill valve and pressure switch there is a mod
cab
Re: Zanussi FX1465W – 914792705/00 Washing machine error
if the drain pump goes down it wont do anything can also take out the board. get into diagnostic position ten read light flashes ….end 2 start/pause 1? drain pump!
cab
Re: WJD1667W ZAN JET
hi, do you know how to access the diagnostic program, sounds like its stuck in a prog, are there 3 lines in the display when its turned on, if not press the pause button then the skip button to advance to the end.
cab
Re: Zanussi Dishasher fault – DE6744 – 91188011/01
motor is started by a 4mf capacitor, is this going o/c when hot?
Re: Zanussi Dishasher fault – DE6744 – 91188011/01
thats what is says for the second and third lightsflashing
Re: Zanussi Dishasher fault – DE6744 – 91188011/01
a) Motor winding interrupted/short-circuited
b) Electrical connections loose / interrupted
c) Motor jammed (foreign bodies/pump unit)
d) Tachymetric sensor interrupted/short-circuitedRe: Zanussi W/Dryer model WDT1072
JUST HAD A LOOK AT THE PICTURES DOESNT SHOW A SEPERATE RESTRICTER. VALVE PART NO. 1240825008. HAS SOMEONE CHANGED IT BEFORE? FITTING NEW ONE AINT TOO BAD, NED TO TAKEBACK OFF TO ALLOW ROOM TO MOVE DRYER PIPEWORK ETC.
CABRe: Zanussi ZT455 D/W
this model was first produced in 1994. the serial no. will tell you the year and week of manufacture i.e. 9401 would be week 1 year 1994. after 2000 they dropped the first 0 in the year so week 1 of 2001 would be 101
hope this helps. by the way you said the circ pump was ok , these had a habit of sticking with unuse, does the impellor turn freely?
cabRe: lg td370040e tumble dryer
hi had loads of trouble, one particular machine changed heater and sensors etc a few times couldnt cure it no help from LG customer got it exchanged from currys, had another samething left the customer last week he was going to LG!
cabRe: Zanussi W/Dryer model WDT1072
hi, there should be a restricter in the valve, the water show only trickle in, never had one leak from there, is there a blockage in the condensor further down?
cab
Re: Zanussi ZT455 D/W
the older models with the syphon tubes did suffer badly, and if left to dry it would fill once, so I think you are going in the right direction. Take the syphon tubes out, if water runs out of them this is a sign the sumps blocked. Try poring boiling water into the syphon chamber, to soften any crap, the remove the water with something like a syringe or suck it out with some pressure hose (try not to suck too hard) Check pink and white hose from the underside of the sump are these full of water, attatch a piece of hose to the summp and blow down it.
hope this helps
cab
