cab

Forum Replies Created

Viewing 15 posts - 31 through 45 (of 423 total)
1 2 3 4 … 27 28 29
  • Author
    Posts
  • October 25, 2011 at 4:47 pm in reply to: AEG FAV60870M Dishwasher Aqua Stop #362091
    cab
    Participant

    Re: AEG FAV60870M Dishwasher Aqua Stop

    I think code I30 is antiflood, leak somewhere

    October 12, 2011 at 8:27 pm in reply to: Zanussi ZWD12270S #361315
    cab
    Participant

    Re: Zanussi ZWD12270S

    dryer element. if the resistance is less than about 10 meg it will cause this

    October 1, 2011 at 3:48 pm in reply to: AEG 14850 #360288
    cab
    Participant

    Re: AEG 14850

    three beeps indicate a 30 code which heating is one off, have you put it into diagnostics to see if there is a code?

    October 1, 2011 at 3:46 pm in reply to: aeg 914002184 #360341
    cab
    Participant

    Re: aeg 914002184

    the front does come off but its an easy zanussi style spring on tub, there isnt much room between the seal and front weight, so if you have fingers like pork sausages you might struggle.

    September 24, 2011 at 1:52 pm in reply to: LG sticks before spin ! #359878
    cab
    Participant

    Re: LG sticks before spin !

    I have had some that dont throw up a code UE and try to redistribute for ages, crap fuzzy logic control

    September 19, 2011 at 3:15 pm in reply to: White Knight 38aw #359061
    cab
    Participant

    Re: White Knight 38aw

    there are only two

    September 19, 2011 at 3:07 pm in reply to: AEG F59740W DW #359256
    cab
    Participant

    Re: AEG F59740W DW

    most likely pcb if heaters ok

    August 22, 2011 at 2:26 pm in reply to: Hoover TD help #357556
    cab
    Participant

    Re: Hoover TD help

    THANKS IADOM.

    espares have them ta.

    August 21, 2011 at 7:22 pm in reply to: Hoover TD help #357552
    cab
    Participant

    Re: Hoover TD help

    If you put it into google it comes up with a list of places to purchase one.

    August 21, 2011 at 6:45 pm in reply to: Hoover TD help #357550
    cab
    Participant

    Re: Hoover TD help

    yep, its on connect but they only have a knob bezel listed, I have checked it a couple of times

    HELP!!!

    August 11, 2011 at 1:13 pm in reply to: Flavel Diswasher DWFA20S #356905
    cab
    Participant

    Re: Flavel Diswasher DWFA20S

    is it a Beko?

    August 11, 2011 at 1:11 pm in reply to: fisher and paykell #357083
    cab
    Participant

    Re: fisher and paykell

    Hi Chris I have the service manual on pdf, but I am away at the mo, back on Sunday, I could email it to you then.
    What model is it?

    Cliff

    April 28, 2011 at 6:53 pm in reply to: matsui d/w 2/3/4 flashing #350059
    cab
    Participant

    Re: matsui d/w 2/3/4 flashing

    look on the fault code list for Haier dishwasher

    April 28, 2011 at 6:48 pm in reply to: Beko DRVS62S #350259
    cab
    Participant

    Re: Beko DRVS62S

    diagnostic
    cancel prog and switch off
    select delicates
    while pressing BUZZER CANCEL switch back on keeping BUZZER CANCEL pressed for 3 secs
    release button the leds should flash
    each time the start button is pushed will run thru the test prog

    if either the CLEAN FILTER or TANK FULL led flash the heaters arnt activated
    if CLEAN FILTER led flashes ntc faulty

    step 1 in test start led blinks
    2 all leds blink
    3 motor rotates a-c’wise
    4 motor a-c’wise and heater on 1400w
    5 motor a-c’wise and heater 2000w
    6 motor and heaters stop
    7 motor c’wise

    April 28, 2011 at 4:23 pm in reply to: Tricity bendix TM310W #350162
    cab
    Participant

    Re: Tricity bendix TM310W

    is the door distorting slightly causing the door switch to open

  • Author
    Posts
Viewing 15 posts - 31 through 45 (of 423 total)
1 2 3 4 … 27 28 29