UK Whitegoods

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 816 total)

1 2 3 … 53 54 55 →

Author

Posts
July 23, 2018 at 6:28 pm in reply to: Indesit Ceramic Hob cycling on and off? #456934

Criscold
Participant

Re: Indesit Ceramic Hob cycling on and off?

The plates will have a temperature limiter built in and this could be normal for the plates to go on/off. if you look at the plate when switched on you will see the limiter probe going across the the plate.

Colin

July 6, 2018 at 6:34 pm in reply to: Ikea/Electrolux Dishwasher – 911679010/04 #456647

Criscold
Participant

Re: Ikea/Electrolux Dishwasher – 911679010/04

I had this a couple of times, check connections A1 & B2 are not reversed on the new board against the old board.

July 31, 2017 at 7:35 pm in reply to: Kenwood dishwasher KDW60X13 #449311

Criscold
Participant

Re: Kenwood dishwasher KDW60X13

You have mail

July 31, 2017 at 4:29 pm in reply to: Kenwood dishwasher KDW60X13 #449309

Criscold
Participant

Re: Kenwood dishwasher KDW60X13

Do a search on curry’s partmaster site they are listed on there

July 1, 2017 at 7:04 am in reply to: HELP lamona oven or hoover oven #448571

Criscold
Participant

Re: HELP lamona oven or hoover oven

This should be the one.

Colin

June 30, 2017 at 7:40 pm in reply to: HELP lamona oven or hoover oven #448569

Criscold
Participant

Re: HELP lamona oven or hoover oven

Is this the correct one ?

February 21, 2017 at 10:27 am in reply to: Zanussi dryer #445475

Criscold
Participant

Re: Zanussi dryer

I don’t know if this will help ?

February 2, 2017 at 7:05 pm in reply to: AEG DISHWASHER NO HEAT #430331

Criscold
Participant

Re: AEG DISHWASHER NO HEAT

You have mail

February 2, 2017 at 10:24 am in reply to: AEG DISHWASHER NO HEAT #430329

Criscold
Participant

Re: AEG DISHWASHER NO HEAT

Do you get any fault codes on this or have you been into diagnostics ?

January 26, 2017 at 10:46 am in reply to: Faulty new beko grill element. #419811

Criscold
Participant

Re: Faulty new beko grill element.

I had the same fault with a Beko grill element in November and now will be 4th visit on a Rangemaster base element.

January 19, 2017 at 6:58 pm in reply to: bosch leak dishwasher #444516

Criscold
Participant

Re: bosch leak dishwasher

Just received a sump repair seal that should solve the problem part no 12005744 fits from inside machine by removing the 4 screws,dropping the sump and pushing the seal into the gap. I should be fitting this on Saturday so will let you know if it works

January 18, 2017 at 6:16 pm in reply to: currys cdw60w10 dishwasher #444568

Criscold
Participant

Re: currys cdw60w10 dishwasher

. If the heating element have heated for 60 minutes, the the rmocouple has not acted, the dishwasher
will shut off all the loads and drain for another 60 seconds af ter pressure switch reset, the alarm buzzer
will ring for 30 seconds, at the same time, the RINSE LIGHT and the DRYING LIGHT coruscate together
then show on after draining

Looks like Heater fault, the above is exactly as stated in manual ?

January 14, 2017 at 11:01 pm in reply to: Bosch Dishwasher SMS65E02GB/07 #444460

Criscold
Participant

Re: Bosch Dishwasher SMS65E02GB/07

Thanks for your help Don

Colin

January 9, 2017 at 8:13 pm in reply to: Kenwood dishwasher fault code E3 KDW60X15 #444313

Criscold
Participant

Re: Kenwood dishwasher fault code E3 KDW60X15

Hi

I think this should help.
http://www.partmaster.co.uk/kenwood/dis … ef=4324163

October 28, 2016 at 3:35 pm in reply to: Whirlpool fcsm9 akz193/IX f03 #442217

Criscold
Participant

Re: Whirlpool fcsm9 akz193/IX f03

That’s the code listed for that service number / model
Author

Posts

Viewing 15 posts - 1 through 15 (of 816 total)

1 2 3 … 53 54 55 →