Forum Replies Created
-
Posts
-
Re: Whats the most annoying thing customers do?
Called on a customer 18months ago and gave him the bad news that his old Hotpoint 1800 series wm that was 20years old was beyond repair, tried to explain that Hotpoint machines are no longer the same standard as his old one and tried to advise him against another Hotpoint. So he bought a Hotpoint WMF740 – I had a callout last week – his bearings had started to get noisy, firstly wouldn’t believe me that it would be the bearings, also wouldn’t believe that it was a sealed drum as his daughter had new bearings slipped into her machine for £50 and expected ME to phone Hotpoint to complain on his behalf !
Re: Lux Ewx14440W Dead
I presume you have tested that you are getting power to the board on U3.1 & U3.2 and the knob spindle is turning in the switch correctly, if so looks like new board req.
Colin
Re: WMA Torx bolts
Same as above but also use one of these – http://cgi.ebay.co.uk/Impact-Screw-Sock … 33651d2e01
Re: Ikea/Whirlpool DWF415 (854541515710)
Have you seen this
http://www.ukwhitegoods.co.uk/modules.p … ic&t=62435Re: Whirlpool ADP4403
Just found this thread
http://www.ukwhitegoods.co.uk/modules.p … ol+pulsingRe: Whirlpool ADP4403
I had one of these with a similar fault continuous flashing and pulsing but if left would eventually carry on the cycle, tested components and replaced NTC but was unable to clear the fault. after finding another thread on here it appears that other engineers have had the same problem and pointed back to the control board but owing to the cost I don’t think anyone changed one. My customer decided to put up with the fault and as far as I know she still has the machine.
Colin
Re: Indesit DI450
Thanks Bob
Have checked heater + cutout back to board but will check pressure switch
ColinRe: Integrated Dishwashers !!!!
Went to one a couple of months ago the customer who just happened to be a solicitor stated that he had tried to remove the machine and needed expert help. after winding up the feet the machine was stuck the the granite worktop and just hung there. quick exit no claims on my insurance thank you
Re: Cheque guarantee scheme ending soon.
I use a company called 123send and have used them for the last couple of years and had no problems with them contact http://www.123SEND.net or phone 08702030123
ColinRe: Tecnic oven TKC8122 PCB
Have you tried BSH on 08448928921 I know they keep some spares for this make
Re: normally open or closed MDI672050210070
I had one of these not heating and this was the problem – This is a safety switch so that the heater is not energised unless water is being pumped You could bypass the switch for testing to see if the heater operates
Re: normally open or closed MDI672050210070
Yes this is normaly open and closes under pressure from pump
Colin
