Forum Replies Created
-
Posts
-
Re: Zanussi FJS1225 PCB not beeping.
DeActivate + Activate OF THE BUZZER AT THE END OF THE PROGRAMME
By pressing the “TEMPERATURE” and “SPIN” buttons at
the same time (or the temperature button with button 4) it is
possible to disactivate the buzzer sound which indicates the
end of the programme; by repeating this operation the
buzzer will be activated again.
This function is always available and is memorized until it is
modified.Re: Known Test Procedures
Beko DE2431 + others with rotary switch
Functional test
to enter the functional test mode , select the knob position 2 while the DW is off
then press the start button and switch the DW on and keep pressing the button for 3 seconds.
All of the indicators turn on for 2 seconds after entering the short program mode.
The following Program lights blink if a fault exists
.
After entering the short program mode, press “start” button and the short program.begins the steps below.
1. Draining (15 seconds)
2. Water inlet (4.4 lt)
3. Water circulation , regeneration (60 sn),
4. Detergent (60 sn), heating (to 65° C) .
5. After reaching 65° , stops heating and water circulation. The water inside is discharged for 30 seconds. then Waits for
the start button to be pressed
Short program mode will be finishedIn the case of a fault, the fault is shown by the following indicators.
All program follow indicators are off No fault
Washing indicator is on Water inlet or water counter is faulty
End indicator is on NTC is faulty
Both indicators are on Heater is faultyAll of the indicators blink after the functional test finishes in the case of no fault occurred
