Forum Replies Created
-
Posts
-
Re: electra ETD447
ETD447 ?
It’s a Crosslee isn’t it ?
Reversing timer at the back if it has one I would think 😉
Dave.
Re: BEKO oven repair
Beko gas ovens are no more difficult to repair that any other oven to be honest, check the repairs@ link below, hopefully there is someone there that can help who specialise in appliance repairs and is Corgi registered 🙂
Dave.
Re: AEG Santo larder fridge always frosting up
Call the engineer back if it was less than 12 months ago, it sounds like there may be an insulation issue to be honest 😉
Dave.
Re: Hotpoint FF200EG buzzes when door is opened
It’s probably a fan making the noise, you just can’t hear it with the door shut 🙂
I would call Hotpoint’s customer service dept as it’s under warranty and ask them to check it out if it’s a lot noisier than when new.
Dave.
Re: Hotpoint Mistral 8596 Fan Problems
The fan motor itself may have failed of course 😉
I think you’ve covered all the other options (apart from a possible PCB fault).
Dave.
Re: Hotpoint WD860P – No cool down on tumble dryer cycle
I know it may seem blatantly obvious but are the fill hoses connected the right way round ?
Although this would effect the wash cycle as well of course 😉
Dave.
Re: WD12 – something missing from door catch?
It looks like a new interlock may do the trick, an email to spares@ukwhitegoods.co.uk if you would like one, please read this first:
http://www.ukwhitegoods.co.uk/modules.p … ic&t=17458
Coincidence ! 😯
Dave.
Re: Indesit WD12X – Door interlock problem.
Sorted over the phone 🙂
For future readers, there are two types of interlock (and quite a lot of the other parts) on this model, the serial number will be required to obtain the correct one quite often 😉
Dave.
Re: Hoover integrated D/W
Normally around the door as you say but it may be behind the kitchen plinth on the kickplate ?
Dave.
Re: manual for the Ariston A1435 Fozzy1
Tried to reply to who madrat ? 😕
PM’s are working fine so there’s no reason why you can’t send and reply to them, unless there’s something up with the settings in your browser of course 😉
Dave.
Re: Baumatic BT904 built in double oven
No, the strike started on Tuesday after the bank holiday, we were told that they were “close to a resolution” every day thereafter, they eventually went back on Monday this week with millions (literally) of mail items backlogged 🙁
Things are definitely moving though as I am getting post that was sent early last week.
Dave.
Re: cannon cambridge double oven mk2
The safety device has failed in that case, Corgi registered engineer time 😉
Please read this:
http://www.ukwhitegoods.co.uk/modules.p … ic&t=16259
Dave 🙂
Re: Smeg/Indesit Oven runners – S1100MFX5
http://www.smeg-service.co.uk/smegshop/index.php 😀
It’s probably the one that Chris mentions I would think.
Dave.
