Forum Replies Created
-
AuthorPosts
-
Dave_Conway
ParticipantRe: Indesit frost free fridge freezer CG1269
There doesn’t appear to be even a service manual listed for this model.
A friendly Merloni engineer required here to help Roly please 😀
Dave.
Dave_Conway
ParticipantRe: Liebherr fridge light heating fridge up
This doesn’t sound correct at all.
I know some fridges use the lamp to aid the defrost process when the unit has cut out, but are you sure they are telling you that the light should be on constantly while the motor is running ?
Dave.
Dave_Conway
ParticipantRe: Diplomat Dishwater – Light on – Code needed
If you can post the model number and which lights are staying on and which are flashing we can advise further.
A new dishwasher of this type, fully integrated etc would cost in excess of £400 to replace by the way, plus the cost of installation 😉
Dave.
Dave_Conway
ParticipantRe: smeg a2a glass for inner main oven door
Part number is 772531406 which is a superseded part, to fit you also need two of 784131080 (seals).
Glass is £39.48 and the seals £2.76 each, inc VAT.
I think for speeds sake, you’d be best to phone Smeg service directly on 0870 444 7002.
Hope this helps.
Dave.
Dave_Conway
ParticipantRe: Servis Door/frame
It’s in stock at Washvac Lawrence 😀
Mind you, it’s priced at £23.97 ex VAT trade ! :eeek:
I don’t suppose GBdar will let you go down that route either, even if it means keeping customer’s happy 😈
Dave.
Dave_Conway
ParticipantRe: Blomberg 1501 AAA vibration
Thanks Clyde, price code H8 though 😯 (£60 ish)
The last time I ordered a complete cross piece from Brandt for an Ocean it came without the bearings and seal, needless to say the insurance company concerned were none too impressed when they had to pay for this plus the two bearings and seal on top 🙄
Dave.
Dave_Conway
ParticipantRe: ATAG cooling fan
AMS wrote:I’ve got a couple of photos of the sticky old one if you’re interested but I have no idea how to upload them
Email them to me Dave if you don’t mind.
T’other Dave 8)
December 15, 2004 at 1:05 pm in reply to: Hotpoint dual fuel cooker 6550 bottom oven glass front size #121484Dave_Conway
ParticipantRe: Hotpoint dual fuel cooker 6550 bottom oven glass front s
annoneill wrote:why couldn’t they suggest that?
The model number is suffixed B for brown or P for polar white so they only bring one up at a time on their screen, the same as I can, but a bit of common sense applied works wonders 😉
Glad to help 😀
Dave.
Dave_Conway
ParticipantRe: Creda 37748E Tumble Dryer Drum not turning
There’s no knack to these condensor dryer belt replacements unfortunately, they are a bit of a nightmare frankly.
It’s a case of take the whole thing apart virtually 🙁
Sorry I can’t be more specific but EU law prevents us from giving direct instructions on fitting parts.
Dave.
December 15, 2004 at 12:08 pm in reply to: HPT BF12P integrated dishwasher: no spring tension on door #121485Dave_Conway
ParticipantRe: HPT BF12P integrated dishwasher: no spring tension on do
They just break normally.
Part number for the straps themselves is 1800806 – £3.17 each, you may also need the guides that they run through, these are 1800805 – £9.13 each.
Dave.
Dave_Conway
ParticipantRe: Creda W100FW stopping mid-cycle
It sounds like it Seamy.
Double check the leads from the tacho aren’t chaffing against the motor case though 😉
Dave.
December 15, 2004 at 11:13 am in reply to: Hotpoint dual fuel cooker 6550 bottom oven glass front size #121482Dave_Conway
ParticipantRe: Hotpoint dual fuel cooker 6550 bottom oven glass front s
If your not bothered about colour, it’s only the white one that is obsolete, the brown one is still available.
Phone Hotpoint again and ask for part number 6100738 😉
Dave.
Dave_Conway
ParticipantRe: diplomat dishwasher ADP8332
This is a Whirlpool made appliance and F1 on these indicates an error in the water temperature sensing circuit. Very probably the sensor itself or NTC device as it’s known.
Not a DIY job to be honest also not a costly job to replace.
If you pop your postcode up or have a look in the directories there should be an engineer who can help with a service visit.
Dave.
Dave_Conway
ParticipantRe: aeg santo 4085 f/f
S’ok 8)
Dave_Conway
ParticipantRe: Hotpoint TDL31 DEAD
If you’re sure the door switch is OK as that’s the usual culprit, it can’t be much else really.
We had one of these recently that appeared dead but was actually powering the heater, that turned out to be the timer at fault.
Dave.
-
AuthorPosts
