[dpr1974]

Re: retiring

Ta, i won’t miss the customers though 🙂

[dpr1974]

Re: hotpoint aqualtis aq9d69u

Thanks, that’s what i thought because i changed the motor today and still the same.
Thanks for the help.

[dpr1974]

Re: hotpoint dh53x fan runs constantly

thanks for that, i’ll check those out.

[dpr1974]

Re: customer damages washer and then wants money back

Evening. George, it all went fine. I told the TS everything and pointed out that i offered to fit the part for free but not the part it’s self, apparently i didn’t even have to offer that.
The customer on the other hand said that i delivered the machine my self and had dropped it out of my van. however, after i sent them the video from my shop showing the husband wheeling it off on his own they accepted to pay for the damage. 😀

[dpr1974]

Re: customer damages washer and then wants money back

Thanks for the replys, Trading standards is my first call on Monday.

[dpr1974]

Re: aeg santo 75388

Thanks Bob.

[dpr1974]

Re: aeg santo 75388

The pnc is 928405953-01. i’ve eliminated the fan as a cause already Bob. 45 versions? bloody hell, i knew there were a few because i’m looking for a freezer draw too and it took a while to find the correct one, then it’s £30 odd quid for the draw and another £30 quid for the front :O

David

[dpr1974]

Re: aeg santo 75388

Hi Bob, sorry i forgot to say it was the white frost type. where is the heater stat located and would you have a wiring diagram for this model?

cheers

[dpr1974]

Re: hpt wt741

This one is sorted, turned out the husband fitted a new display board for a different fault before i got there and neglected to tell me, and it was the wrong one.

[dpr1974]

Re: fridge problem

Sorry for the delay, work has soared and this is still at the back of the workshop. plus i forgot to check for a reply 🙁 sorry.

[dpr1974]

Re: Hoover hnmf2605a l-80

Sorry for the delay, bloody bt has been doing “improvement work” so no internet for a bit.
Thanks Martin for the offer but criscold has pm me the instructions already.

many thanks

[dpr1974]

Re: Hoover hnmf2605a l-80

any one know?

[dpr1974]

Re: hotpoint RFB50P f/f

can any body help?

[dpr1974]

Re: chinese zanussi zwf1221w

Thanks Martin for the offer but i tested the pressure switch and found the problem.

[dpr1974]

Re: chinese zanussi zwf1221w

Sorry about that Martin, i assumed this was chinese as the only e34 i could find in the UKWG fault guide was under chinese zanussi.
would be the only thing i didn’t check 🙁

many thanks

[Author]

Posts