Forum Replies Created
-
Posts
-
Re: Zanussi washing machine Jet System TurboDry 1600
when you say you got an error signal what did you see ?
Dave
Re: Looking for a powerful upright for pet hair – advice?
I am afraid I look at which with a lot of scepticism. some of the product they recommend I would not buy.
what you have to remember is appliances need to pass 2 tests 1) they must do the job 2) they must last long enough to be cost effectivetake spares access on the 2 cleaners and a simple part, motor brushes. Sebo available Dyson new motor and lists like this go on. Add to this fact the sebo is much more reliable and it has my vote. How many Dyson cleaners are used in offices and shops like Sebo units are
Dave
Re: Adrian Welke
sounds good he is just a troll after all. Anyway what did you ever do to him to deserve this?
keep me posted, will be fun to watchDave
Re: Bosch WVD2452SGB – Washer/Dryer – Dispenser to drum pipe
Bad news is you have got one of the difficult ones. during manufacture the hose was put in the drum then the locking ring is put in from the inside. Don’t think I have ever successfully put one back but at least at the top you may be able to Debor it but you will have to tell the customer and make sure they realise is not your fault if it leaks again. apart from that its drum out as far as I know
unless anyone else know differentDave
Re: Adrian Welke
https://www.musixmatch.com/lyrics/Fland … -Prejudice
well Flanders and Swan got this Welshman correct but I had better be diplomatic after what they say of the scots lol
Dave
Re: bush wiring diagram
yes it is a long shot as they are made by various manufacturers
any other numbers on it that may give clue as to who made it ?
Dave
Re: Zanussi ZWI70201WA. PN 914528134/00
from what you are saying, no light at all on the panel and the pump runs all the time
sounds like a board fault.
strip it out and look for damage and shorted pump triac (although if that was short I would expect an E23 fault )
Dave
Re: Parts Needed – Sharp Microwave S85ST
they sound like standard part to me
Magetron need the number on top of it (something like 2m236-m42)
diode well they are pretty universal
capacitor need an exact value something like 0.8uF 4100volts
Dave
Re: neff microwave c57w40m0gb/03
just to answer my own post
changed Mag fault cured.
Old mag had Aerial damage, heater ok and did not seem to have reading to earthDave
Re: smart-sure
how about uploading the contract here. lets all have a gander
spares account is ok if parts are free but if not they could be overpriced
also a bit worried as it seems you are becoming a sales person for them. so if it goes bang you get the flack
Dave
Re: AEG F55002V10P leaking
grooster wrote:Ive had loads of sump hoses go on these machines. They don’t always show up straight away but when it gets hot and subtle the tiny hole near the seam opens up. (sump to heater hose) I always carry one on the van now.
thanks that’s worth knowing. Bet it drove you nuts trying to find that one lol
Dave
Re: AEG oven fault
most of the time tripping in a cooker is one of the elements with low insulation
on your cookers there are a lot of them.
try the oven in all modes and see if it trips. your main oven can be used in fan oven mode (using single element at the back) and also convection mode ( using upper and lower element). the grill cavity can also be used as a grill and also as a small ovenI find a lot of the lower elements fail through lack of use as elements can get damp if they are not used for long periods of time
Dave
