[fasetester]

Re: Bosch washing machine new brushes fitted

Motor check OK Dave one connection reads o ohms the other read between 4 and 5 ohms from each brush the other connections on the motor read open which connection should I read the TOC on on the motor is the taco inside this motor thanks fasetester.

[fasetester]

Re: Bosch washing machine new brushes fitted

Thanks reaper for your reply to remove PCB plug and do a continuity test going to motor is this to test for broken wires to motor could you explain the are in pairs thanks fasetester

[fasetester]

Re: Bosch washing machine new brushes fitted

Thanks Martin for your reply traced wires from plug on PCB. Relating to the 3 wires that came away from motor plug from right to left on PCB plug so that is the I replaced them on motor plug 123 tested again no go .

The motor plug is numbered from 1to8 no numbers on PCB plug so I don’t know if my connect are right.

[fasetester]

Re: Bosch washing machine new brushes fitted

Thanks Dave for your reply I did test the connections on the motor see my reply to motor resistance reading fasetester

[fasetester]

Re: Bosch washing machine new brushes fitted

What is the most likely component to have blown on this PCB to affect the motor action I have tested the diodes around where the the board is blacked only getting meter reading one way on diodes .

There is 2 black cinder cap not domed on top 2 blue rectangular components small square coil 4 resistors one blue round component .

Then the triac how can you tell which is T1 T2 G when testing thanks case tester

[fasetester]

Re: Bosch washing machine new brushes fitted

Thanks Martin as Jim said the machine would fill pump out when selected spin program would only set to 1200 spin not able to select 1600 spin

Would start on 12 min count down to 11min then jump to 1min stop removed PCB there is a sign something happened PCB blackened around diode near the triac

Should there not be a fuse to protect the PCB fasetester

[fasetester]

Re: Bosch washing machine new brushes fitted

Thanks Martin what resistance reading should I get from the motor between 2-3 20 ohm between 3-4 open between 4-5 5ohms between 5-6 o ohms between 6-7 o ohms top to bottom thanks fasetester

[fasetester]

Re: Bosch washing machine new brushes fitted

Thanks Jim for your reply when removing the connector from motor 3 of the orange wires came away from the connector in the motor plug not sure which connection the go into fasetester

[fasetester]

Re: Bosch washing machine new brushes fitted

Thanks Dave for your reply fasetester

[fasetester]

Re: Bosch washing machine new brushes fitted

Thanks Dave could you please tell me how to reset it thanks fasetester

[fasetester]

Re: Inner oven glass shattering on Electrolux

OK thanks captain cave man fasetester

[fasetester]

Re: Inner oven glass shattering on Electrolux

Thanks Martin for the reply tried all my tork bits nothing fits to remove the top of the inside of the oven frame where glass slides in nothing will grip them to remove them is their a special bit I see the handle is held on to the outside glass with star heads fasetester

[fasetester]

Re: Inner oven glass shattering on Electrolux

could anyone tell me is the door frame on this oven pop riveted before I drill them out thanks fasetester

[fasetester]

Re: Inner oven glass shattering on Electrolux

Before I take the door apart could any tell me is the frame popriveted before I drill them out thanks fasetester

[fasetester]

Re: Inner oven glass shattering on Electrolux

OK ken thanks fasetester

[Author]

Posts