Forum Replies Created
-
Posts
-
Thanks Stratford girl for your reply if element was shorting out would fuse not blow or electric trip out fasetester
Thanks guys for your reply that lock look different from the interlock on this machine have the changed it fasetester
Thanks kaibart for your reply most them don’t would a ordinary self tappers do some don’t even have a screw attachment just the pips would even be more secure if you could attach them with 2 screws
As far as I know Dave just keep spinning can’t select any program so won’t disgage from spin is spares still not available for these bush machines thanks fasetester
How likely is it that the plastic pulley could have damaged the splines on the drum shaft and a new pulley will not fit the teeth on the pulley have completely worn away and is the bolt self locking or better to use some tread lock thanks fasetester
Any information on putting machine in diagnostic program if there was a fault with motor would it wash as normal but not spin or could be PCB fault and which component could be the problem thanks
Went back to check dryer cleaned condenser cleaned channel at the back took of pump cleaned all out was full of sodden fluff .
checked pump for broken propeller all OK pump running OK float in bad shape a bad float should not stop pump sending water to drawer .
checked hoses and jet at back drawer when running dryer with side panel off water spitting out of condenser end of program no water in drawer puddle on the floor thanks fasetester
