franz

Forum Replies Created

Viewing 15 posts - 301 through 315 (of 411 total)
1 2 3 … 20 21 22 … 26 27 28
  • Author
    Posts
  • September 14, 2009 at 9:27 pm in reply to: Hotpoint WT540 Module #297055
    franz
    Participant

    Re: Hotpoint WT540 Module

    isnt the 3 phase machine fitted with a brushless motor?
    Franz

    September 11, 2009 at 3:24 pm in reply to: ANS #296801
    franz
    Participant

    Re: ANS

    TC do you use AW services for parts as advised because their postage costs for small one off orders seem very high and I assume if ANS dont send me too many calls then one off orders will be the norm.
    FRanz

    September 10, 2009 at 3:08 pm in reply to: beko d533 cooker #296749
    franz
    Participant

    Re: beko d533 cooker

    Thermal fuse will have blown – take back off – there are 2 thermal fuses -one for oven & one for grill – built into wiring – looks a bit like a resistor covered in sleeving
    Franz

    September 7, 2009 at 2:28 pm in reply to: indesit kd3c1(w)/g ceramic electric cooker #296502
    franz
    Participant

    Re: indesit kd3c1(w)/g ceramic electric cooker

    Connect list it as working table glass @ £133.32 + vat

    Franz

    September 1, 2009 at 5:23 pm in reply to: LG 12336FD #296021
    franz
    Participant

    Re: LG 12336FD

    4986er1006a
    in stock at connect & qualtex – qualtex much cheaper
    Franz

    August 29, 2009 at 9:39 am in reply to: Hoover HD98e #295703
    franz
    Participant

    Re: Hoover HD98e

    Did that Mike – all looks o.k. – can only assume that a relay is knackered
    Franz

    August 26, 2009 at 7:00 am in reply to: gas appliances #295413
    franz
    Participant

    Re: gas appliances

    Telford college in Edinburgh do the courses u require
    Franz

    August 21, 2009 at 10:51 am in reply to: Eurolec rf006 #295187
    franz
    Participant

    Re: Eurolec rf006

    Thanks Ken
    Franz

    August 20, 2009 at 7:11 am in reply to: Hotpoint FDW 20 Door Leaks #295069
    franz
    Participant

    Re: Hotpoint FDW 20 Door Leaks

    Graham, has the seal definitely gone as a split lower wash blade will cause m/c to leak at door
    Franz

    August 19, 2009 at 9:40 pm in reply to: Whirlpool part number #294861
    franz
    Participant

    Re: Whirlpool part number

    ran it thru SIOS – no matches – so I guess not
    Franz

    August 13, 2009 at 4:13 pm in reply to: KENWOOD ck230 #294398
    franz
    Participant

    Re: KENWOOD ck230

    066078 -ess602 – it does tell you on parts list on connect
    Franz

    August 11, 2009 at 6:39 am in reply to: TDS cd rom #294300
    franz
    Participant

    Re: TDS cd rom

    Phone 01325 302464 (Electrolux Distriparts)
    Franz

    July 27, 2009 at 8:35 pm in reply to: bosch washing machine stuck showing 1 minute #293289
    franz
    Participant

    Re: bosch washing machine stuck showing 1 minute

    did one today with same fault – open circuit heater- common on m/c’s with pcb

    Franz

    July 26, 2009 at 9:56 pm in reply to: How to do an insulation test on a built in cooker. #293140
    franz
    Participant

    Re: How to do an insulation test on a built in cooker.

    would’nt it just be easier to remove oven from housing?
    Franz

    July 26, 2009 at 9:24 pm in reply to: How to do an insulation test on a built in cooker. #293137
    franz
    Participant

    Re: How to do an insulation test on a built in cooker.

    Read roly’s reply properly – u don’t test from consumer unit – you test from cooker unit or isolator – unless u disconnected wires at consumer unit before testing u would be testing all circuits on board
    Franz

  • Author
    Posts
Viewing 15 posts - 301 through 315 (of 411 total)
1 2 3 … 20 21 22 … 26 27 28