Forum Replies Created
-
AuthorPosts
-
franz
ParticipantRe: Servis M6160w
Thanks guys – will solder new carbons into holders
Franz
franz
ParticipantRe: Diplomat adp3220 door hinges (oven)
Thanks Chris
Franz
franz
ParticipantRe: Proline PDW081S lights on, nobody at home
Repaired one of these today – same fault – door microswitch at fault – this machine is an old indesit design – part number for switch is c0041194- Remember to unplug it first.
Franz
franz
ParticipantRe: wd12x uk eprom, module help!
Basically its a micro chip with the model number and relevant programmes on it – you will have to order one and fit it in the receptacle on the module
franz
ParticipantRe: Hotpoint WD865 problem.
Does not matter that you haven’t registered warranty – as long as you have the receipt. -It wont work on wash only as fault will still be detected by module – call out hotpoint and make them suffer.
Franz
franz
ParticipantRe: Samsung SR44RMB
Thanks Bryan I’ll try that
franz
ParticipantRe: pat test
The point I was trying to make was that you can’t criticise other peoples work (especially if they have not done anything wrong) if you don’t know the regs.
franz
ParticipantRe: pat test
45p for a plug is not the point – if you are doing pat testing you’ve got to know the job.
franz
ParticipantRe: Admiral top loader
Thanks guys – it looks like it is the snubber so i’ll pass it on to someone with a death wish. Anyone got the Samaratans phone number?
franz
ParticipantRe: Ariston KLS9NUK dishwasher door floppy
Sorry mate – springs or wires have come off hinges – machine will have to come out to repair as sides have to be sprung to get access to hinges – may be poss to pull forward about halfway and just remove screws down front edges to gain access
franz
ParticipantRe: pat test
plugs with unsleeved pins are not an automatic fail. The legislation is not retrospective and therefore if the plug is otherwise sound, i.e no cracks then it is legal but it could not be transferred to a new mains lead or another appliance as this would contravene the regs – I have just done the C&G 2377 pat testing course and this was one of the questions raised
franz
ParticipantRe: mis selling
Get your facts right this machine was made in Britain in the Hotpoint factory only part that is truly Indesit is the PCB – Indesit is just the parent company – poor build quality & design is down to previous Hotpoint management
franz
ParticipantRe: TDS OFFLINE
Squadman – tried copying files onto hard disk first time round and it was still requesting CD1 – What is connections?
franz
ParticipantRe: Indesit K642VSXG Not working 🙁
It’s illegal as you are not qualified to diagnose any gas faults which may be present on appliance – better call in a qaulified engineer just to be safe.
franz
ParticipantRe: Indesit WIL153 Error Lights
lights 1+2 = F12
modules not communicating – check & refit all module conns if this does not fix fault – both pcb’s will have to be replaced plus eeprom. sometimes just pulling connections off & then refitting will cure it – remember to unplug first -
AuthorPosts
