[gegsy]

Re: Bosch d/w SGI43E02GB/08

Hi
This model does have a flow meter/impellor jug fitted.
If required p/no 424099.
I would also look at the transfer ribbed hose (the usual suspect) aswell

Greg

[gegsy]

Re: Bosch WFO2855GB/01 no spin.

Hi
On rare occasions Ive had this and sometimes thoroughly cleaning the carbon dust from around motor has worked but usually its an irrepairable damged com thats at fault 😥
Only cure is a new motor 144616

Model is WFO285SGB/01 😀

Greg

[gegsy]

Re: Whirlpool S20DFSS10-A/G Control Board Problems

Hi
You aren’t using one of those energy saver plugs are you??
http://www.ukwhitegoods.co.uk/modules.p … t=savaplug

Greg

[gegsy]

Re: Bosch SGS43A18GB/17 poor drying

ChrisR wrote:😳 You`re right there Gegsey,I never have read the manual!.

:rotfl:

[gegsy]

Re: Bosch SGS43A18GB/17 poor drying

Thats the procedure I explained Simon, in the above reply 😉
Yes it is in the manual, but they never read it :rolls:

Greg

[gegsy]

Re: Bosch SGS43A18GB/17 poor drying

Only as above AFAIK

Greg

[gegsy]

Re: Electrue Selling To General Public

Try Maytag aswell :rolls: http://www.maytag.co.uk/ServicePages/parts.aspx

Greg

[gegsy]

Re: Barclays Premier League 2007 – 2008 / Champions League

Good footy over the weekend.
Nice to see Villa destroy Chelski 😀

Greg

[gegsy]

Re: neff cooker hood wiring diagram

Penguin45 wrote:You’ll have to ring BSH Appliance Care (08705 543210), ask for technical and be very nice to them. They might send you one if you have the full eNr and Fd numbers.

Penguin45.

Not anymore, they will not give any tech info out now.
The message says its down to Health and Safety issues.

Greg

[gegsy]

Re: Bosch American Fridge Freezer problem – help & advic

Hi
Its got to be worth £65 to assess as it was an expensive bit of kit when new.
We also have engineers which are equally qualified to work on such appliances, please use the link for an engineer below.
The job in question would take a suitably qualified engineer approx 1 hour or less to repair; just to give you a ball park idea.

Greg

[gegsy]

Re: Bosch American Fridge Freezer problem – help & advic

Hi
These were made by Maytag and damn good side by side IMHO 😉
To fix this one you would ideally need to change –

172834 Fountain kit
172830 Sleeve
172833 Microswitch
480378 PCB
266803 Housing (If solenoid has overheated and distorted it)

All available from spares@ukwhitegoods.co.uk I would get prices first and then get a stiff drink 😯 😀

Unplug appliance if you are to attempt yourself :plug:

Greg

[gegsy]

Re: Maytag GC2224GEKB side by side

Thanks John you’re a star.

Greg

[gegsy]

Re: Hotpoint FDW20P error Codes

Hi Jim
Cheers for that, I did spot that but just needed affirmation. 😀
Also found now after your post on Page 35 of the super duper UKW Fault Code Book available here
http://shop.ukwhitegoods.co.uk/product_ … ts_id=1635

Greg

[gegsy]

Re: Bosch SGS43A18GB/17 poor drying

You could try this Simon…….

Hold down the S2 button and switch on the appliance. “0” is indicated on the digital display. If the Normal button is pressed again, “1” is displayed and intensive drying is switched on. If the appliance is switched off, the value is saved. If intensive drying is activated, the temperature is increased by 3 K in the final rinse.

S2 is the third button along, counting one below 7 seg as the 1st button.

Greg 😉

[gegsy]

Re: Washer broke!! 3years old, used everyday shall I buy new

Hi
Please don’t double post it just gets messy, cheers.
Double post removed 😉

Greg

[Author]

Posts