Forum Replies Created
-
Posts
-
Re: Whirlpool Manual Model ADP256WT
Hi
I have a feeling this is quite an old appliance hence the lack of information available 😕Greg
Re: Whirlpool ADG7540 problems….
Hi
Almost certainly a weak recirculation motor or blockage.
Power off if you are to investigate.Greg
Re: 2 and a half year Bosch dishwasher needs replacing
Hi
Sounds like something else. Re check the wiring if you took it off PCB before.It does drain 1st? If so is the water to appliance turned on?
Power off first.
GregRe: Whirlpool Manual Model ADP256WT
Hi
Im sure its WH at the end, but to be sure find the 12 digit number below the barcode and use that. ie 85xxxxxxxxxxGreg
Re: 2 and a half year Bosch dishwasher needs replacing
Hi
If you use the link for an engineer below, Im sure they will be able to assist you 🙂Greg
Re: Hygena AHY0132
Hi Lisa
With this being a gas appliance I can only insist you call a Corgi registered engineer out to sort this problem. Sorry.Greg
Re: whirlpool american style fridge freezer
Hi
Its not a known issue.
The only reason I can think that the paddles broke is that air maybe getting into the ice bucket, say from a poor door seal or the ice dispenser flap not sealing fully and thus semi melting the ice cubes into a block of ice that the paddles would struggle with.Greg
Re: 2 and a half year Bosch dishwasher needs replacing
Hi
Its a pretty routine solder job and the module is behind the fascia at the front.Greg
Re: WFF2000 – assorted symptoms & pre-wash LED flashing
Hi
That error code indicates a turning problem which I think we have deduced.
When you say “clicking” noise; if you turn the drum by hand is that noise apparent then?With the appliance unplugged, the first point of call would be motor brushes.
They should be approx 1.5 inches in length from new.
If they are barely above 10mm from holder then you will need to replace them.
Available from spares@ukwhitegoods.co.uk, p/n 154740 @ £20.50 + VAT etc.Greg
Re: 2 and a half year Bosch dishwasher needs replacing
Hi
Its not actually the relay thats burnt out but rather one of the pins of the relay that goes through the PCB.
All it needs is cleaning up a bit and resoldering.Un plug appliance if you or anyone is to attempt this :plug:
Greg
Re: Whirlpool AWZ 8812 Condensor Dryer steam from door/overh
Hi Steve
I would have thought that the bottle should fill a bit even if the seal has snapped.
Just to clarify, the seal seals the fan manifold at the front not around the fan itself.Greg
Re: Whirlpool AWZ 8812 Condensor Dryer steam from door/overh
Hi
All done from the rear.
Do you have the 12 digit NC number, usually below a barcode, just so we can identify exactly 😀 as there are a fair few with that model number.Greg
