Forum Replies Created
-
Posts
-
Re: Bosch WFF2000 Removing brushes
Hi
Most likely the heater, a check with a multimeter should reveal app 30 ohms.
Access is from front, so no need to pull appliance out 😀 not a bad job IMHO, if in any doubts there is always the engineer link below.
Heater if required is p/no 263726 – £27.90 +VAT +costs and is available from spares@ukwhitegoods.co.ukUn plug appliance before attempting any work on it. :plug:
GregRe: Bosch WFF2000 Removing brushes
Hi
Pre-wash lamp 2 blinks = fault in the heating circuit.
Machine usually with this fault, faults after 85 minutes.
GregRe: Neff B1320 – lack of power
Hi
Have you set the clock and selected manual operation (hand symbol) in display.Greg
Re: Bosch Aquasensor fault
Remove front lower plinth to gain access to innards, pipe will then be visible 😀
Greg
Re: bosch replacement pan and rack also gas hob electronic r
Hi
The new installations now have to be hard piped, older may be on flexi hose.
I appreciate that you want to clean under it but there is a chance that if it is hard piped, you may put stress on the joint/s and comprimise the pipe soundness ie – cause a leak that may or not be detected by sense of smell.
A quick look under the hob will reveal if its hard or flexi piped.Greg
Re: Dishwasher – Siemens Avantgarde SE25831
Hi
Have a look here http://www.ukwhitegoods.co.uk/modules.p … ll+problemGreg
Re: bosch replacement pan and rack also gas hob electronic r
In that case its more than likely the ignition unit or spark button/ gas tap switch array thats at fault; without a model its hard to tell which you have 😕
As Martin has previously stated, you will need a Corgi engineer, even though it is the electrical side. 🙂Greg
Re: Bosch SKT 2022 does not wash
mark224 wrote:Penguin45: Do you know what p/n 065553 is for?
Im sure he does 🙂 its the drain/empty pump.
Greg
Re: Siemens Oven – HB55055gb/01 error 4
Hi
You either have a faulty oven PTC or an electronic unit fault within the temp measurement range.
The sensor readings are as follows –Temp in deg C /Ohms
0 = 500
50 = 590
100 = 680
200 = 870
500 = 1400Er4, Would have the following reaction to the appliance. It does not heat up, fans switch over to run-on. Following correct temperature measurement, the fault is cleared and the cooker heats up again.
HTH
Greg
