[gegsy]

Re: Bosch WFT2800GB/13

……..or you could order from the UKW shop http://tinyurl.com/q2w7x
not geared really for trade but in this instance a significant price difference.
You will need to do a bit of soldering thats the only bug bear 😉

Greg

[gegsy]

Re: Bosch WFT2800GB/13

Hi
The motor will split in half to reveal the brush module unit.
BSH p/no 496876 £31 +VAT if you should require it.

Greg

[gegsy]

Re: Whirlpool adg7540 dishwasher cold water only

You very welcome Butch, let us know how you get on 😉

Greg

[gegsy]

Re: Whirlpool adg7540 dishwasher cold water only

Its either going to be a faulty module or faulty NTC which Ive had in the past even though its not showing a fault code flash/s.
I think its going to be engineer time in all fairness, please check the link below.

Cheers

Greg

[gegsy]

Re: Whirlpool adg7540 dishwasher cold water only

Thats fine but you need to set the meter range correctly.
It should have read 28ohms which is about right for the heater.

Greg

[gegsy]

Re: Gas Installation in Tavistock, Devon

Hi Mike
You could Find a Corgi engineer here

Greg 😉

[gegsy]

Re: Bosch Maxx WFO 2860 – Heating element?

Could be element,ntc or module.
With the unit unplugged check for resistence on heater terminals, with the wires removed 😉

Also can you put the full model number found on the door and rear of the appliance, cheers.

Greg

[gegsy]

Re: Neff dishwasher top spray arm dosn’t rotate

You will need to get the model thats etched onto the side of the stainless steel door.
It could be a few things but will be able to tell you more when you supply that.

Greg

[gegsy]

Re: Ariston Margherita A1435

As far as I know Turkey is the place of manufacture. Reasonable appliances, refrigeration particularly reliable and good value.

Greg

:offtopic:

[gegsy]

Re: Ariston Margherita A1435

The knob is just a selector on that machine. If you move it mid cycle, the module gets confused hence the knob clicking itself to infinity and beyond.
If its on a programme leave it alone, it has enough problems without any external meddling trust me 😆

Greg

[gegsy]

Re: zanussi door wont lock

Says pre-programmed, still fiddly to fit though.
Engineer may be best course to take me thinks.

Greg

[gegsy]

Re: Whirlpool adg7540 dishwasher cold water only

I think DP has telepathetic powers 😆

Greg

[gegsy]

Re: zanussi door wont lock

If its the PCB as P45 suggested then its p/no DST973914791191005
around the £160 mark.

Greg

[gegsy]

Re: Whirlpool adg7540 dishwasher cold water only

DentedPorsche wrote:Test the heater as Penguin suggests

I resemble that remark 😆

Greg

[gegsy]

Re: dishwasher whirlpool G2P DW1 another error 4 flashes

No you fine, I shouldn’t assume 😀

Greg

[Author]

Posts