[gegsy]

Re: Bosch SGS5342GB/1,7 FD8105 excessive cycle time,not drai

Hi
Yes yours does have a turbidity sensor and running the hottest wash may just do the trick.
Rinsing plates etc before loading will help also 😉

Greg

[gegsy]

Re: Neff T1113N1EU Hob

Hi
Given the FD of 8303 I would definately say its a T1113N1EU/03
Regulator is 173071 not 09503 😕

Greg

[gegsy]

Re: Bosch WTA 3500 Tumble Dryer Door Catch

IIRC, the door outer panel should just pop off, if carefully teased away from the inner door 😉

Greg

[gegsy]

Re: bosch no fast spin

Hi
FYI – Cycles max spin speeds are –

Cottons +Linens 1200rpm
Easy care 800rpm
Delicates 600rpm
Woolens 800rpm
Rinse/Freshen Up 800rpm
Spin 800rpm

HTH

Greg

[gegsy]

Re: Neff Hinge replacement U1661

Penguin45 wrote:Two screws through the door for the handle and a couple along the bottom edge should let the halves separate, from memory….

Good memory :tup:

Greg

[gegsy]

Re: Recommended Listening

Ohhhhhhhhh and Corrs especially Andrea 😀

Greg

[gegsy]

Re: Bosch FF – ice forming at bottom

Hi
Turn off appliance for a min of 48 hrs 😯
Then you will need to remove rear panel in freezer cavity and and make sure drain channel in bottom centre is clear all the way to the spout above plastic bath above motor/compressor at the rear.

Greg

[gegsy]

Re: Bosch WTA3200GB/06 drier – no heat

Should only heat in the clockwise direction 😀
If the limit temp is reached onthe NTC it will switch the heat off for app 2 mins

HTH

Greg

[gegsy]

Re: Bosch tumble dryer WTA3100

Hi Lee
The WE applies to ALL trade members and the rules apply as P45 said, to ALL posters.

Greg

[gegsy]

Re: BOSCH WTL6103GB Tumble Dryer Won’t Stay Hot

I take it the load was relatively damp?
Also the drum paddles (sensors) can become coated by fabric softener/scented sheets residue.
If the appliance is in a room which may at times be less than 5C, this will also give you this fault.

Worth eliminating these before throwing anymore parts at it 😀

Greg

[gegsy]

Re: Bosch F/F Board Fault?

I would say faulty PCB IMHO 😉
Temp faults would cause alarm to sound and NTC fault/s would put appliance in a sort of fail safe.
Display LEDs should stay lit as they are merely temp settings and not actual compartment temps.

Greg

[gegsy]

Re: Bosch beeping.

That is odd, if its adjustable its usually in the manual. 😕
Oh well, lets hope Mac is sorted anyway 😀

Greg

[gegsy]

Re: Bosch beeping.

Would be in his user manual if the bugger could be bothered reading it 😆

Greg

[gegsy]

Re: Recommended Listening

So are you a classical fan K 😕
I was forced from an early age to digest and enjoy the classics ie Saint Saens and the likes (Carnival of the Animals ) its just not my bag baby (Austin Powers quote)

Greg

[gegsy]

Re: Recommended Listening

Tis good though 😉 and oh some Human League 😀
Classical, there you go with the negative vibe (Kelly’s Heroes quote)

Greg

[Author]

Posts