Forum Replies Created
-
Posts
-
Re: How the ****did that get in there
cornwell40 wrote:Wasn’t a Servis was it
Twas an old Ocean, with the S/S tub.
Evidentely, the S/S on the tub wasn’t thick enough 😕
Re: How the ****did that get in there
OO, OO! 😀 Are we doing this thread again?
The most spectactular thing I every saw, was a fifty pence piece, that had turned sideways in between the inner and outer drum, and it had cut through the metal outer tub like a tin opener!
Sliced the thing clean in two, and made a spectactular mess 8)
Re: Zan DW – DES959
Thank you 🙂
That’ll be another ‘salt-action tablets’ job for me then :rolls:
The ultra soft water round here is a pain sometimes!
Re: ISE10…covered by guarantee?
Aye, I’ve give the filter a good wash, and haven’t heard anything from the customer since (2 week).
kwatt wrote:…most of the dust in your house will be skin flakes as we shed a horrendous amount of the things…
Don’t you watch QI? 😉
Re: ISE10…covered by guarantee?
I’m being generous because it’s one of Goatboy Senior’s mates :rolls:
Re: ISE10…covered by guarantee?
If it happens again, Ima give them a loaner and investigate thoroughly 😉
Re: ISE10…covered by guarantee?
Went to it yesterday afternoon, and as usual, the filter is clean, and the fluff is gathering under the door and in the fan housing 🙁
I can’t see anything wrong with the door assy, but there must be a reason why the filter is being by-passed?
Re: ISE10…covered by guarantee?
kwatt wrote:If they use the dryer solely for towelling…
Aye. Towels! All day, every day 🙁
Re: ISE10…covered by guarantee?
Goatboy wrote:…they’re going to let me know how the new seal affects it.
2 weeks later, and apparently the fluff is still by-passing the filter, hence F02, and I’ll be clearing out the fan again 😕
I’ll probably be looking at this tomorrow. Does anybody have any ideas, beside getting Shaun to send me an entire door 😆
Re: Miele CTD
Joy!
Twas one of the relays on the PCB. There’s a little PCB for the heater. Two lives and a neutral, and the neutral relay wasn’t switching 😕
Re: Miele CTD
🙁 Cr@ppers!
New sensor hasn’t fixed it! The TOC is fine, new sensor, I stripped the thing down, and there’s no blockages anywhere.
Everytime (any heat prog.) after 2 minutes, it goes into fault, and it flashing 2nd light down (machine iron).
Anyone have any sugguestions?
Re: Connect Distribution/Merloni spares
Surely the point of this thread is to complain about Electrue, and I’d like to do just that! They thoroughly deserve a good, hard kick in the ballards for their level of service.
The only reason they are good, is because they stock the wierd little things other people don’t. Beside that, I can’t think of a good thing to say about them.
Everytime I deal with them lately, something goes t1ts-up, and I don’t even get a sorry from the generic telephone-monkey!
They suck! :protest:
