hf

Forum Replies Created

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • in reply to: The Fault Code Guide #369885
    hf
    Participant

    Re: The Fault Code Guide

    Can someone please explain the 3.99 for 30 days bit in the app store i’m guessing that it lasts longer than that.
    Thanks Jay..

    in reply to: Hotpoint fdl 570 can’t program #372141
    hf
    Participant

    Re: Hotpoint fdl 570 can’t program

    nah checked all that had to get 2 extension leads to be able to hold progger and plug in, was thinking my progger is fried as the first pcb that i got was definitly faulty as it activated the dispenser solenoid soon as i plugged in. But if i put the progger in another machine with out the card the red light comes on…..
    I’m at a loss what to do have been trying to get a hotpoint engineer to look at it but they just want to sell me a new pcb which its got already

    in reply to: Electrolux 727043 Glasswasher #355881
    hf
    Participant

    Re: Electrolux 727043 Glasswasher

    ones i have seen drain some water on the rinse as clean rinse water is being added,, but if it continues to drain check the second level pressure switch is dropping back..

    in reply to: Hotpoint Washer Dryer WD63 Eating TOC Kits #229392
    hf
    Participant

    Re: Hotpoint Washer Dryer WD63 Eating TOC Kits

    Check the fan motor wires are ok and not intermittent.
    Did you change the cycling stat??

    in reply to: indisit 30613 #189080
    hf
    Participant

    Re: indisit 30613

    I’m not exactly sure which one this model is but check the fan chamber has not got a rubber sleeve to the ducting which has come off therfore not pulling enough air over the heater..
    Also it may seem obvious but check the vent’s not blocked I’ve caught myself out on this one b4..

    in reply to: Candy Sprint 120 washer #189072
    hf
    Participant

    Re: Candy Sprint 120 washer

    The door locks do go short and blow the fuse but you can just disconnect them to test..
    What is the fault you are getting?

    in reply to: Servis washing machine. #188607
    hf
    Participant

    Re: Servis washing machine.

    Servis mainly have dmp**** series modules on that are very temprimental on spinning I get loads of trouble with them….
    One thing I have found though is try a new belt first this seems to cause a few probs but only on about 2/10 I’d say….The feed back on the o.o.b. seems to be a very weak point on these…

    in reply to: Miele W863 “rinse light flashing” #188675
    hf
    Participant

    Re: Miele W863 “rinse light flashing”

    Has anyone done a pro series miele with the first rinse light flashing i had one the other day but it had an inverter board and induction motor. Motor seemed fine but i didnt want to risk buying board on the chance, they had been quoted “about” £600 my miele……

    in reply to: Bosch Washing machine stops with 3 minutes to go. #188569
    hf
    Participant

    Re: Bosch Washing machine stops with 3 minutes to go.

    I did a built in neff(bosch) the other day that stopped on 3 mins it was just the pump blocked. Go there first i’d say….

Viewing 9 posts - 1 through 9 (of 9 total)