[HotDog]

Re: hotpoint dwf31.no go.

Sounds like board to me had same fault about ayear ago part number 1801875 iwas unable to run last error code so i went for board not a cheep job but very good machine 8)

[HotDog]

Definate float chamber fault

[HotDog]

Re: Hotpoint WM73

DItto heater prob been caught by drum 8)

[HotDog]

Re: wma66

I have had same fault on four of these machines no motor action fitted chopper board did the trick every time

[HotDog]

Re: Nardi Integrated Dishwasher model 200341035460

Thanks Dave will go for latch first 😀

[HotDog]

Re: Nardi Integrated Dishwasher model 200341035460

Hi Dave, sorry for the delay hope you come back to this post model number is LSISH A000.

Thanks Bob i will phone the customer to check the top basket wheels, but the door did close firmly when i checked it.

[HotDog]

Re: Hotpoint D/washer FDW80G…Not Starting?

Is there any water in side when you open door it will not start if the pump is blocked

[HotDog]

Re: Diplomat 8322

Thanks dave i did not doubt chris just needed some thing to back with Ciff

[HotDog]

Re: Diplomat 8322

I phoed supplier today gave them part no 481236158334 for circ pump they came back with 481236158432 anyone confirm is this correct

[HotDog]

Re: Diplomat 8322

Thanks chris for part no will phone my supplier in morning for price just trying get rough cost to give cust a clue this evening

[HotDog]

Re: Hotpoint Twin Tub wash pump.

I have two gen washpumps canspare one cliff

[HotDog]

Re: hotpoint timer?

wm timer 9042409 02 part no 1602271 green label 800/1000 rpm mk2 wm timer9042409 01 part n0 1601613 white label 800/1000 rpm mk1 .I do not think you can revert to 01 I poss will have the timer you req collecting dust in my work shop small fee ! 😆

[HotDog]

Re: Hotpoint DWF33P/41

Have you checked spray arm is not blocked i have had same fault found orange pip 😆 s stuck in arm

[HotDog]

Re: H/Point T/L Suport Tube

If you can spare the time to strip machine down to the bellows seal on the supp/tube providing the alloy is not rotting to bad near carbon face seal you can remove bellows and wire brush around this area glue bellows back on tube using debor sealant do not fix spring clip back on till dry you must fit new sping seal in drum or take spring out of seal stetch and refit bit fiddly but does work also cleanbowl support were topseal fits a touch of washing lliquid on all carbon face seals refit finish of with new cork washer” phew”iam knackerd now . It does work i have done this many times and it does stand thetest of time.

[HotDog]

Re: AEG dishwasher pump

Thanks guys did not expect Q/tex to supply take it these are none gen

[Author]

Posts