Forum Replies Created
-
Posts
-
Re: Rangemaster ToledoXT 110 (d/f)
common problem with these lately…supposedly due to lead free solder that they now have to use due to EU regulations…the solder just does not stick as it should, wires drop off fall wherever and go bang!
Order a new warming plate and all will be well!Re: WHIRLPOOL d/w ADP4501 fills for 1 min then dr/pump activ
Probably flashes 7 times and it would be the flow switch..located on the fill chamber on the left hand side of the appliance as you look at it!
Had exactly the same fault last month and was a bitch to locate 😆
Hope this helps..Jazz
Re: Repairers Required
Hiya…still no email!!
I assume you have got all the guys you need then! :rolls:Jazz
Re: Zanussi DA 6142 No D/Washer
As above..common fault with theses is for the heater relay on the main pcb to blow its’ solder…check the board and all joints on the relays!
Jazz
Re: Diplomat d/w ADP8322
Thanks for your help guys…turned out it was the AIR BREAK ASSY which includes the little board(mentioned above)!
All done and all working great..thanks again!Jazz
Re: Diplomat d/w ADP8322
ok this is ongoing now! 😕
I replaced the board and the fault returned although now i have the start light flashing 7 times..so at least i have a fault.As far as i am aware this points to the flow switch..please correct me if i am wrong!
i have replaced the flow pressure switch to no avail.Appliance still drains…starts to fill for approx 10 seconds then the fills and pumps at the same time and beeps…..Anymore advice anyone PLEASE!!! :rolls:
Jazz
Re: Diplomat d/w ADP8322
the 1st led on the left hand side..think it is the rinse stays on but does not flash and you cannot do anything unless you reset the programme!
Re: Repairers Required
sent you an email to have a chat with me about this over a week ago…as of yet…no reply!! 🙁
Re: URGENT INDUCTION HOB ADVICE PLEASE!
Have repaired numerous dedetrich induction hobs under warranty and extended cover.They seem quite good but you MUST make sure they have room beneath them for air to circulate.Failure to do this can cause boards to blow due to overheating!
