Forum Replies Created
-
AuthorPosts
-
kwatt
KeymasterRe: Baumatic oven B600MC – selector switch
https://shop.ukwhitegoods.co.uk/0700672 … tor-switch
Stock available as well. 😉
K.
kwatt
KeymasterRe: Miele TwinDos / Hydrogen Peroxide
Ah okay, not a clue then and I doubt Miele will be too keen to tell you but, they’re the only people that will be able to do so.
K.
kwatt
KeymasterRe: Miele TwinDos / Hydrogen Peroxide
Miele says…
Frequent use of chlorine increases the risk of component damage. The use of agents containing chlorine, such as sodium hypochlorite and chlorine bleach in powder form, can damage the protective upper surface of stainless steel and cause corrosion to components. Factors affecting this are chlorine concentration levels, contact time and temperature. It is therefore advisable to avoid the use of such agents. Oxygen based bleaching agents should be used instead. If, however, chlorine based bleaching agents have to be used for particular types of soiling, then anti-chlorine measures must also be carried out. If this is not done irreparable damage can occur to components in the machine and to laundry.
Anti-chlorine treatment has to be carried out immediately after chlorine bleach has been used. The use of hydrogen peroxide or an oxygen based cleaning or bleaching agent is recommended and the laundry should not be drained in between. With thiosulfate, especially when used with hard water, gypsum can form, which can lead to incrustations on laundry or deposits in the machine. The use of hydrogen peroxide is preferable as it aids the chorline neutralising process. The exact quantity of additives and the treatment temperatures required must be set and tested on site in accordance with the dosage recommendations of the detergent and additive manufacturers. The laundry must also be tested to check whether it contains any active chlorine residues.
So basically, no.
K.
kwatt
KeymasterRe: Beko zb531 top drawer
Nope, it’s been removed from Beko’s system completely. 🙁
K.
kwatt
KeymasterRe: Beko zb531 top drawer
Beko only show two in it, lower and then three all the same but it’s ancient so very possibly obsolete and just deleted.
Beko do that, just drop stuff off and don’t show it at all when it goes obsolete. Then you don’t know it’s actually obsolete unless you figure out the logic in it.. such as it is.
K.
kwatt
KeymasterRe: In search of the fourth cord
I was just reading that, I do admire’s Dave’s patience with the guy.
K.
kwatt
KeymasterRe: warranty on spare parts
B2B, pretty much you be stuffed.
B2C, only obligation is statutory rights must be given.
If you want the full position it’s here:
http://www.ukwhitegoods.co.uk/help/spar … pare-parts
Written for consumers but pretty much applies to trade although they may have diminished rights under the SoGA on a B2B transaction as, shocker to many, businesses do not have the same rights as consumers.
K.
kwatt
KeymasterRe: AWOL
Great news Don.
I don’t blame you so if you can’t make it then, you can’t make it and too bad really, health first.
K.
kwatt
KeymasterRe: February 2018 WTA conference
Wow!
There’s over 200 people now registered and most all major manufacturers, spares distributors and more there.
That’s the most people ever I believe.
A long way from a few people having a drink and a chat in a pub!!
K.
kwatt
KeymasterRe: SAMSUNG dropping service partners ?
That I don’t know.
But getting that into bed with one manufacturer… very dangerous.
K.
kwatt
KeymasterRe: Smeg Sp680mfd selector switch
811730069
Not obsolete, just not easy to get.
K.
kwatt
KeymasterRe: SAMSUNG dropping service partners ?
I have heard that they were trying to reduce the head count and have super agents.
Probably so they can boss them about more knowing Samsung. 😉
K.
kwatt
KeymasterRe: Montpellier Fridge Compartment freezing
It is this one:
https://shop.ukwhitegoods.co.uk/3001491 … tor-sensor
Where it’s mounted though, not a clue as they do not show it on any of the diagrams.
It’s a case of tracing it all out to find it.
K.
kwatt
KeymasterRe: Montpellier Fridge Compartment freezing
Probably the thermistor in the fridge is faulty or not reading correctly.
I’d need the 22 digit serial number to find the correct one for you.
K.
kwatt
KeymasterRe: smeg gas hob – burner won’t stay on
Nice to know that there’s always another expert o hand.
Fact is, thermocouple fails, shut off activates as it should do so, to all intents and purposes for most laypersons, the thermocouple is a shut off or an extension of that device. I doubt they care for the technicalities of it all.
Semantics aside of course.
K.
-
AuthorPosts
