kwatt

Forum Replies Created

Viewing 15 posts - 2,206 through 2,220 (of 25,830 total)
  • Author
    Posts
  • in reply to: SMEG DI6012 leaking – Error E1 #450258
    kwatt
    Keymaster

    Re: SMEG DI6012 leaking – Error E1

    You’ll usually see traces where the water’s been.

    K.

    in reply to: SMEG DI6012 leaking – Error E1 #450256
    kwatt
    Keymaster

    Re: SMEG DI6012 leaking – Error E1

    You need to work out where the leak is.

    K.

    in reply to: Fridge never stops running #450232
    kwatt
    Keymaster

    Re: Fridge never stops running

    No, common enough way to think but sadly incorrect.

    The freezer gets the cold gas first then it goes to the fridge so, if the compressor is not pumping as it should then the problem of not cooling correctly will first be seen in the fridge as, the gas is then too warm by the time it gets there and, it doesn’t chill down correctly.

    What you will almost certainly find is that the freezer is cycling warm, as in, not reaching a mean temp of -18?C, it will still freeze perhaps but it won’t be freezing properly. To “freeze” it only needs to get past 0?C or so, but to safely store frozen food it needs to be a lot colder than that. Which also means that the food that you’re storing in it will not be getting kept correctly and can even prove to be unfit for consumption.

    K.

    in reply to: Fridge never stops running #450230
    kwatt
    Keymaster

    Re: Fridge never stops running

    It’s not getting down to temperature so, probably a compressor issue.

    K.

    in reply to: Fridge never stops running #450228
    kwatt
    Keymaster

    Re: Fridge never stops running

    Two options. One is okay (ish) the other you ain’t gonna like.

    Thermostat is faulty and the contacts closed so it runs all the time.

    Compressor is faulty.

    Former, easy enough and not too expensive. Latter, not so much.

    K.

    in reply to: Dead Aeg ÖKO-LAVAMAT 88730 #450201
    kwatt
    Keymaster

    Re: Dead Aeg ÖKO-LAVAMAT 88730

    Without the PNC…

    Mains filter, terminal block?

    Open it up and look for anything obvious.

    K.

    in reply to: HJA6740 Lamona larder fridge Auto defrost appears not to wor #450194
    kwatt
    Keymaster

    Re: HJA6740 Lamona larder fridge Auto defrost appears not to

    Could be a sensor problem but I’d try defrosting it fully first.

    K.

    in reply to: Whirlpool to do a recall on Hotpoint dryers #431646
    kwatt
    Keymaster

    Re: Whirlpool to do a recall on Hotpoint dryers

    Quite.

    There is no clarity on much of anything in this whole debacle, same with the fridge thing as well.

    What I can tell you is that, to me, it’s trial by media.

    If this was a serious murder investigation and perhaps some of those calling for corporate scalps were on the receiving end of being accused of similar crime of that magnitude the evidence would have to be a lot, lot stronger than what has been seen on this thus far.

    But hey, what do I know. :rolls:

    K.

    in reply to: 560mm wide washing machine? #450192
    kwatt
    Keymaster

    Re: 560mm wide washing machine?

    To my knowledge, such a thing no longer exists I’m afraid.

    K.

    in reply to: Oven door glass needed. #450179
    kwatt
    Keymaster

    Re: Oven door glass needed.

    That can be found here, if it’s the outer one:

    http://shop.ukwhitegoods.co.uk/69253267 … door-glass

    K.

    in reply to: Hot Point Fridge Freezer FFM70A unable to run compressor #450157
    kwatt
    Keymaster

    Re: Hot Point Fridge Freezer FFM70A unable to run compressor

    That buzz (hum), click is the overload doing its thing which is protecting it from being a danger.

    The compressor is either overheating to the point where it could be considered dangerous and the safety is doing exactly as it should to prevent risk.

    Or, the compressor has had it.

    K.

    in reply to: Goodbye “Yellow Pages” #450140
    kwatt
    Keymaster

    Re: Goodbye "Yellow Pages"

    Is that not dead already?

    K.

    in reply to: Whirlpool to do a recall on Hotpoint dryers #431644
    kwatt
    Keymaster

    Re: Whirlpool to do a recall on Hotpoint dryers

    On top of…

    http://www.itv.com/news/wales/2017-08-1 … est-hears/

    in reply to: Russell Hobbs RHSLDW2 PCB #450079
    kwatt
    Keymaster

    Re: Russell Hobbs RHSLDW2 PCB

    No info on that one anywhere, probably one there’s no support for.

    K.

    in reply to: AWOL #269774
    kwatt
    Keymaster

    Re: AWOL

    Enjoy. 😀

    K.

Viewing 15 posts - 2,206 through 2,220 (of 25,830 total)