Forum Replies Created
-
Posts
-
Re: Bertazzoni induction failure
If all the zones are faulty it’s either going to be a power issue of some sort or control module failure as there’s no way all the zones would fail at once.
K.
Re: Bertazzoni induction failure
Thus far, I don’t know who is carrying out service on Bertazzoni the the UK.
K.
Re: Beko WMD 26145 T does not start spinning
normally, if there’s no display, the lit lights are a fault code and often they will flash to indicate a problem.
The heater is buried at the back of the tub unit, bottom, just above the motor and if it’s open circuit it will need replaced.
K.
Re: Miele 7634 "Clean Out Airways" warning.
It may be detecting a blockage internally.
Sadly there’s no tech available for Miele at all so, you’re kinda stuck with asking them to do it and they know how to charge.
K.
Re: Beko WMD 26145 T does not start spinning
Normally you’d get a fault code but if it fills then stops, heater is the first thing to look at.
K.
Re: Brand new Lamona LAM8301
Bet it’s being twisted slightly by the cabinet or the install.
I’d wager yet another replacement will do exactly the same.
K.
Re: Whirlpool 6th sense usual story
To be honest, at that age I’d give up as I don’t think it’s worth spending any significant money on.
K.
Re: For a clearer understanding watch this..
I managed the first minute or so before I realised that it was a propaganda video.
K.
Re: Built in diplomat oven
Pretty much, yes.
The generic ones are a lot cheaper anyway though, you can find those here:
https://shop.ukwhitegoods.co.uk/generic … grill-pans
K.
Re: Built in diplomat oven
No, it doesn’t appear to exist.
Either that or is completely obsolete with no parts available now.
K.
Re: Brand new Lamona LAM8301
I’d agree with Steve, sounds like a classic install error.
Normally either the cabinet is twisted in some manner or the door is out of whack so it doesn’t close correctly and, given that water will run down with gravity the bottom of the door is the most probable place it’ll leak from.
On some even them not being correctly levelled can give you that problem.
The chance of two faulty with exactly the same problem is just so remote it’s unreal. As if it was a production issue every one would be the same, not just the ones you happened to get.
K.
